Clutch “No Release” Problems

Clutch “No Release” Problems

Poor clutch release makes it difficult to start and stop the vehicle or change gears.

“No release” is probably the most common of all clutch problems. The purpose of the clutch is to couple and decouple the engine and transmission. Poor clutch release makes it difficult to impossible to start and stop the vehicle or change gears.

Common Clutch release problems

Air in a hydraulic release ­system;

A flywheel that has been machined too thin; or

A flywheel where the step or cup dimension is out of ­specification.

Another condition may be that the disc damper can interfere with flywheel crank bolts, resulting in no release as well. Flywheel step and cup dimensions are critical to proper clutch operation. Too tall of a step or too shallow of a cup can create a “thick disc condition.” A thick disc condition will reduce or eliminate clearance between the disc, flywheel and clutch friction surfaces and cause release problems. Flywheel runout should also be inspected.

The conditions listed above account for the majority of “no release” problems, but other, less common conditions do contribute to no release, as well: Bent drive straps on the clutch, worn pilot bearings, a bent release fork, or a worn or binding release cable can all contribute to release problems. Any component in the release system that flexes, like a fork or firewall, can “absorb travel” and cause no release.

Causes of Clutch Release Problems 


  • Contaminated hydraulic fluid;
  • Incorrect release system adjustment;
  • Air in the hydraulic release system;
  • Defective or worn release system ­components;
  • Defective or worn pedal bushings or ­brackets; or
  • Flexing of the firewall or any release ­component attachment point.


  • Misalignment of clutch components;
  • Corroded, damaged or improperly lubricated input shaft splines;
  • Worn pilot bearing/bushing;
  • Worn bearing retainer;
  • Bent or worn release fork or pivot ball;
  • Worn linkage components;
  • Stretched release cable;
  • Excessive or incorrect flywheel machining;
  • Bent clutch drive straps;
  • Bent or distorted disc;
  • Improper transmission lubricant; or
  • Improper bolting of the clutch.

Courtesy of Schaeffler Group USA

You May Also Like

Taking the Fear out of ASE Testing

Spring registration now open; Register by June 30.

Because many people experience test-taking anxiety, the National Institute for Automotive Service Excellence (ASE) has put together useful tips and online resources to help take the fear out of testing. An infographic can be found in the Test Taking & Prep section of the website and is ideal for posting in shops or providing to service professionals. The infographic features common questions and solutions like those below to help individuals overcome their concerns and achieve the goal of ASE certification.

BMW Wheel Bearings

Two technologies are being used that are allowing engineers to put better bearings in smaller packages.

Livestream Next Week: Lowering Springs and Lift Kits

Join Andrew Markel and the industry experts from Summit Racing on September 14, 2022 at 1:00 pm EST.

LED Lighting – What Are the OES Doing and What Can You Do?

Andrew Markel discusses LED lighting and answers questions from students at Bullard-Havens Technical High School.

Hyundai Brake Caliper Fluid Inspection

This procedure can be used to inspect and identify fluid which may appear around the brake caliper area.

Other Posts

Axle Torque Procedures

Guessing the correct torque setting is a bad idea.

Manual Transmission Service

Parts that wear out must be replaced.

Manual Transmission Failure Causes

One of the most common reasons behind why a manual transmission fails is lack of lubrication.

Livestream SOON: LED Lighting

Join the Experts from Summit Racing & Babcox Media’s Tech Group for a discussion about LED lighting on May 25 at 1PM EST.