VW: Noise From Front End When Steering Wheel Is Turned

Main Navigation

Advertisement
Social Connect
Resources
Our Brand Family
Brake and Front End Magazine
Technical Resources for diagnosing and servicing undercar components
Chassis

Tech Tips: Volkswagen: Noise from Front when Steering Wheel is Turned

Follow these steps to diagnose a noise when the steering wheel is turned on a Volkswagen.

Brake and Front End Staff
By Brake and Front End Staff
Published:

Volkswagen logoModel

All models except 2010-2015 Routan

Related Articles

Condition

Squeaking/creaking noise from front of vehicle while fully turning steering wheel.

Technical Background

The ribs of the outer CV boot may contact one another when the steering wheel is fully turned. This has the possibility to create a squeak or creak noise. The noise may be more prevalent in wet weather.

Service

If the noise is determined to be coming from the outer CV boot ribs coming in contact with each other, no further work is required. Please explain to the customer that this is a normal condition and may be more noticeable in wet weather. Note: This contact does not affect the service life or the function of the components and is considered normal. DO NOT replace parts for this concern.

Courtesy of AllData

You May Also Like

Chassis

Ride Height Sensors

If one of these sensors is replaced, it must be calibrated after it is installed.

Andrew Markel
By Andrew Markel
Andrew Markel is the director of content for Brake & Front End magazine. He has been with Babcox Media for 20 years. He is a technician and former service writer and holds several automotive certifications from ASE and ­aftermarket manufacturers. He can be reached at [email protected].
Published:

Ride-height sensors not only measure the position of the suspension, but also the rate of movement. They are supplied with a voltage of around 5 volts. The signal voltage is changed as a magnet moves past a coil. Most sensors have three wires — ground, power and signal.

Internally, it is difficult to damage one of these sensors. Externally, the linkage that connects the sensor to the suspension arm can also be damaged. The connector can be damaged and cause a short or open and a code will be set. If one of these sensors is replaced, it must be calibrated after it is installed.

Read Full Article

More Chassis Posts
Ride Control For Electric Vehicles

Replacement units are available from sources other than the dealer.

By Andrew Markel
Brake Pad Edge Codes

The “Edge Code” can tell you information about a brake pad’s friction material.

By Andrew Markel
Chassis Parts and Alignment Angles

Knowing why the adjustment is required is critical to performing the total alignment.

By Andrew Markel
Suspension Upgrades – Selling Shocks and Struts

The question customers fail to ask is, what is “best” for their vehicle?

By Andrew Markel

Other Posts

Diagnostic Test Drive For Drivetrain

A driveshaft center bearing can fail due to the bearing and the rubber isolator.

By Brake and Front End Staff
Mercedes 4MATIC Diagnostics

The Mercedes-Benz 4MATIC all-wheel drive (AWD) systems have been around for a while now.

By Brian Sexton
Air Ride Suspension Diagnostics

The key to understanding the logic of air ride systems is using service information.

By Andrew Markel
Steering Angle Sensor Operations

It is important for the ABS/ESC module to receive two signals to verify the steering wheel’s position.

By Andrew Markel