Tech Tip: Infiniti Front End Popping/Squeaking/Clunking Noises

Tech Tip: Infiniti Front End Popping/Squeaking/Clunking Noises

Applied vehicles: 2004-’10 Qx56 (JA60) [all 2004-’09 and 2010 vehicles built before: 5N3ZA(*)N(**)AN 904401]

If you confirm:

A noise (clunking squeaking popping) can be heard when performing at least one of the following actions:

– turning the steering wheel left or right;

– driving over speed bumps;

– driving on rough roads;

– accelerating or decelerating; and

The noise is coming from the front stabilizer bar bushing.

Actions:

Replace the front stabilizer bar bushing on both sides (RH and LH) with P/N 54613-ZV50A.

– Refer to the FSU section of the applicable ­electronic service manual for removal and installation instructions.

– Before installing the new bushings, use Nissan Brake Cleaner (or equivalent) to clean the stabilizer bar where the bushings make contact. See Fig. 1.

Fig. 1

Courtesy of ALLDATA.  

You May Also Like

Ride Height Sensors

If one of these sensors is replaced, it must be calibrated after it is installed.

Ride-height sensors not only measure the position of the suspension, but also the rate of movement. They are supplied with a voltage of around 5 volts. The signal voltage is changed as a magnet moves past a coil. Most sensors have three wires — ground, power and signal.

Internally, it is difficult to damage one of these sensors. Externally, the linkage that connects the sensor to the suspension arm can also be damaged. The connector can be damaged and cause a short or open and a code will be set. If one of these sensors is replaced, it must be calibrated after it is installed.

Ride Control For Electric Vehicles

Replacement units are available from sources other than the dealer.

Brake Pad Edge Codes

The “Edge Code” can tell you information about a brake pad’s friction material.

Chassis Parts and Alignment Angles

Knowing why the adjustment is required is critical to performing the total alignment.

Suspension Upgrades – Selling Shocks and Struts

The question customers fail to ask is, what is “best” for their vehicle?

Other Posts

Air Ride Suspension Diagnostics

The key to understanding the logic of air ride systems is using service information.

Steering Angle Sensor Operations

It is important for the ABS/ESC module to receive two signals to verify the steering wheel’s position.

Chassis Alignment

The source of the complaint can be the angles, electronics or tires.

Laying Out Your Shop for ADAS/EV Repairs

With so many vehicles equipped with some form of ADAS, rethinking your electronics layout or plan might be in order.