Tech Tip: In-Line Power Steering Filter

Main Navigation

Advertisement
Social Connect
Resources
Our Brand Family
Brake and Front End Magazine
Technical Resources for diagnosing and servicing undercar components
Chassis

Tech Tip: In-Line Power Steering Filter

Particles not removed during the flushing process or particles from everyday wear of components and hoses cause valves to stick and block fluid flow. When replacing any power steering component, always flush the entire system and then install an in-line filter.

Brake and Front End Staff
By Brake and Front End Staff
Published:

Application:
All power steering equipped vehicles.

Related Articles

Problem:
Premature failure of power steering components.

Cause:
Particles not removed during the flushing process or particles from everyday wear of components and hoses cause valves to stick and block fluid flow.

Solution:
When replacing any power steering component, always flush the entire system and then install an in-line filter such shown below (part 20-0038F). Be sure to use OE recommended or equivalent fluid, see Pro Tech 20-0027 for more information.

Note: This ProTech bulletin is supplied as technical information only and is not an authorization for repair.

Tech Tip courtesy of CARDONE Industries, Inc.

You May Also Like

Chassis

Ride Height Sensors

If one of these sensors is replaced, it must be calibrated after it is installed.

Andrew Markel
By Andrew Markel
Andrew Markel is the director of content for Brake & Front End magazine. He has been with Babcox Media for 20 years. He is a technician and former service writer and holds several automotive certifications from ASE and ­aftermarket manufacturers. He can be reached at [email protected].
Published:

Ride-height sensors not only measure the position of the suspension, but also the rate of movement. They are supplied with a voltage of around 5 volts. The signal voltage is changed as a magnet moves past a coil. Most sensors have three wires — ground, power and signal.

Internally, it is difficult to damage one of these sensors. Externally, the linkage that connects the sensor to the suspension arm can also be damaged. The connector can be damaged and cause a short or open and a code will be set. If one of these sensors is replaced, it must be calibrated after it is installed.

Read Full Article

More Chassis Posts
Ride Control For Electric Vehicles

Replacement units are available from sources other than the dealer.

By Andrew Markel
Brake Pad Edge Codes

The “Edge Code” can tell you information about a brake pad’s friction material.

By Andrew Markel
Chassis Parts and Alignment Angles

Knowing why the adjustment is required is critical to performing the total alignment.

By Andrew Markel
Suspension Upgrades – Selling Shocks and Struts

The question customers fail to ask is, what is “best” for their vehicle?

By Andrew Markel

Other Posts

Replacing Your Power Steering Reservoir

Discover why simply flushing out contaminants from power steering reservoirs may not be sufficient to prevent potential failures.

By Brake and Front End Staff
Hydraulic Power Steering Service Opportunities

Hydraulic power steering is still the choice for some platforms and applications.

By Andrew Markel
Air Ride Suspension Diagnostics

The key to understanding the logic of air ride systems is using service information.

By Andrew Markel
Power Steering Pull

Every driver has a different threshold for a pull.

By Andrew Markel