CHRYSLER & JEEP: Compass/Patriot/Caliber Front Suspension Creak or Squeak When Cold

Main Navigation

Advertisement
Social Connect
Resources
Our Brand Family
Brake and Front End Magazine
Technical Resources for diagnosing and servicing undercar components
Chassis

CHRYSLER & JEEP: Compass/Patriot/Caliber Front Suspension Creak or Squeak When Cold

Andrew Markel
By Andrew Markel
Andrew Markel is the director of content for Brake & Front End magazine. He has been with Babcox Media for 20 years. He is a technician and former service writer and holds several automotive certifications from ASE and ­aftermarket manufacturers. He can be reached at [email protected].
Published:

Untitled Document2011-’14 Compass/Patriot

Related Articles

2011-’12 Caliber

Condition: The driver may describe creaking or squeaking noises coming from the front suspension. The noise is typically more noticeable during cold temperatures below 40°F. The noise may go away when the temperature warms up.

Cause: The front lower rear control arm bushing is making the noise.

Remedy: Lubricating the bushing with Nye synthetic lubricant (part number 05018626AA) will get rid of the noise. To access the rubber bushing, the control arm needs to be removed from the vehicle. With the control arm in a vise, insert a pry bar or socket wrench extension into the hole and move the bushing so the grease can be applied to the exposed surfaces.

Courtesy of Mitchell 1.

You May Also Like

Chassis

Ride Height Sensors

If one of these sensors is replaced, it must be calibrated after it is installed.

Andrew Markel
By Andrew Markel
Andrew Markel is the director of content for Brake & Front End magazine. He has been with Babcox Media for 20 years. He is a technician and former service writer and holds several automotive certifications from ASE and ­aftermarket manufacturers. He can be reached at [email protected].
Published:

Ride-height sensors not only measure the position of the suspension, but also the rate of movement. They are supplied with a voltage of around 5 volts. The signal voltage is changed as a magnet moves past a coil. Most sensors have three wires — ground, power and signal.

Internally, it is difficult to damage one of these sensors. Externally, the linkage that connects the sensor to the suspension arm can also be damaged. The connector can be damaged and cause a short or open and a code will be set. If one of these sensors is replaced, it must be calibrated after it is installed.

Read Full Article

More Chassis Posts
Ride Control For Electric Vehicles

Replacement units are available from sources other than the dealer.

By Andrew Markel
Brake Pad Edge Codes

The “Edge Code” can tell you information about a brake pad’s friction material.

By Andrew Markel
Chassis Parts and Alignment Angles

Knowing why the adjustment is required is critical to performing the total alignment.

By Andrew Markel
Suspension Upgrades – Selling Shocks and Struts

The question customers fail to ask is, what is “best” for their vehicle?

By Andrew Markel

Other Posts

Diagnostic Test Drive For Drivetrain

A driveshaft center bearing can fail due to the bearing and the rubber isolator.

By Brake and Front End Staff
Air Ride Suspension Diagnostics

The key to understanding the logic of air ride systems is using service information.

By Andrew Markel
Steering Angle Sensor Operations

It is important for the ABS/ESC module to receive two signals to verify the steering wheel’s position.

By Andrew Markel
Chassis Alignment

The source of the complaint can be the angles, electronics or tires.

By Andrew Markel