GM Tech Tip: Slap Or Clunk From Rear Leaf Spring

GM Tech Tip: Slap Or Clunk From Rear Leaf Spring

Some customers may comment on a rear leaf spring "slap" or "clunk" noise. This noise is most apparent when the vehicle is operated over irregular road surfaces. The rear leaf spring tip inserts may have broken apart from wear and fallen out, or may be severely worn or damaged.

Models

• 1999-2012 Chevrolet Silverado 1500/2500

• 2000-2012 Chevrolet Suburban 2500

• 2002-2006 Chevrolet Avalanche 2500

• 2003-2012 Chevrolet Express 2500/3500 Vans with 8500 GVWR (RPO C5F), 8600 GVWR (RPO C6P) or 9600 GVWR (RPO C6Y)

• 1999-2012 GMC Sierra 1500/2500

• 2000-2012 GMC Yukon XL 2500

• 2003-2012 GMC Savana 2500/3500 Vans with 8500 GVWR (RPO C5F), 8600 GVWR (RPO C6P) or 9600 GVWR (RPO C6Y)

Condition

Some customers may comment on a rear leaf spring “slap” or “clunk” noise. This noise is most apparent when the vehicle is operated over irregular road surfaces.

Cause

The rear leaf spring tip inserts may have broken apart from wear and fallen out, or may be severely worn or damaged.

0-gm leaf spring tech tipCorrection

Important: DO NOT disassemble the main pack on the leaf spring or remove the bushing from the spring.

Verify that the rear leaf spring tip inserts (1) are present on the leading and trailing ends of the overload spring (second stage leaf), and inspect the condition of the inserts. If the inserts are either not present or severely worn or damaged, install new inserts.

Important: On some models, the vehicle may have to be raised to allow the springs to separate enough so the insert can be installed.

Courtesy of ALLDATA

You May Also Like

Ride Height Sensors

If one of these sensors is replaced, it must be calibrated after it is installed.

Ride-height sensors not only measure the position of the suspension, but also the rate of movement. They are supplied with a voltage of around 5 volts. The signal voltage is changed as a magnet moves past a coil. Most sensors have three wires — ground, power and signal.

Internally, it is difficult to damage one of these sensors. Externally, the linkage that connects the sensor to the suspension arm can also be damaged. The connector can be damaged and cause a short or open and a code will be set. If one of these sensors is replaced, it must be calibrated after it is installed.

Ride Control For Electric Vehicles

Replacement units are available from sources other than the dealer.

Brake Pad Edge Codes

The “Edge Code” can tell you information about a brake pad’s friction material.

Chassis Parts and Alignment Angles

Knowing why the adjustment is required is critical to performing the total alignment.

Suspension Upgrades – Selling Shocks and Struts

The question customers fail to ask is, what is “best” for their vehicle?

Other Posts

Air Ride Suspension Diagnostics

The key to understanding the logic of air ride systems is using service information.

Steering Angle Sensor Operations

It is important for the ABS/ESC module to receive two signals to verify the steering wheel’s position.

Chassis Alignment

The source of the complaint can be the angles, electronics or tires.

Laying Out Your Shop for ADAS/EV Repairs

With so many vehicles equipped with some form of ADAS, rethinking your electronics layout or plan might be in order.