Arnott Now Offering AMK Air Suspension Compressor For 2005 To 2014 Land Rover Discovery III/LR3, Discovery IV/LR4 And 2006 To 2013 Range Rover Sport

Arnott Now Offering AMK Air Suspension Compressor For 2005 To 2014 Land Rover Discovery III/LR3, Discovery IV/LR4 And 2006 To 2013 Range Rover Sport

ArnottArnott Air Suspension Products — a leader in aftermarket air suspension products and accessories — announced it has added a new air suspension compressor to its line of OES replacement pumps with the introduction of an AMK pump for the 2005 to 2014 Land Rover Discovery III and LR3, the 2005 to 2014 Discovery IV and LR4, the 2006 to 2009 Range Rover Sport including Supercharged, and the 2010 to 2013 Range Rover Sport excluding Supercharged.

The AMK compressor is made by the same company the OE uses to replace the original Hitachi pump. OEM numbers are: LR045251, LR015303, and LR023964.

This compact, maintenance-free AMK compressor — Arnott Part Number P-2645 — retails for $699.80. Arnott assembles this pump in the USA with a vehicle-specific support bracket to ensure a fast and easy installation. The energy-efficient, quiet compressor comes with an integrated air dryer unit, 18-piece vibration isolator kit, new air line fittings, electrical connection, compressor pressure hose, and a new compressor relay.

Features:
• Modular and Compact Design
• Maintenance-Free Design
• Includes Dryer and Compressor Relay
• Pre-assembled with Support Brackets
• Detailed Installation Manual

The part is backed by Arnott’s Two-Year Limited Warranty.

You May Also Like

Ride Height Sensors

If one of these sensors is replaced, it must be calibrated after it is installed.

Ride-height sensors not only measure the position of the suspension, but also the rate of movement. They are supplied with a voltage of around 5 volts. The signal voltage is changed as a magnet moves past a coil. Most sensors have three wires — ground, power and signal.

Internally, it is difficult to damage one of these sensors. Externally, the linkage that connects the sensor to the suspension arm can also be damaged. The connector can be damaged and cause a short or open and a code will be set. If one of these sensors is replaced, it must be calibrated after it is installed.

Ride Control For Electric Vehicles

Replacement units are available from sources other than the dealer.

Brake Pad Edge Codes

The “Edge Code” can tell you information about a brake pad’s friction material.

Chassis Parts and Alignment Angles

Knowing why the adjustment is required is critical to performing the total alignment.

Suspension Upgrades – Selling Shocks and Struts

The question customers fail to ask is, what is “best” for their vehicle?

Other Posts

Air Ride Suspension Diagnostics

The key to understanding the logic of air ride systems is using service information.

Steering Angle Sensor Operations

It is important for the ABS/ESC module to receive two signals to verify the steering wheel’s position.

Chassis Alignment

The source of the complaint can be the angles, electronics or tires.

Laying Out Your Shop for ADAS/EV Repairs

With so many vehicles equipped with some form of ADAS, rethinking your electronics layout or plan might be in order.