Arnott Introduces Reman Front OE Air Struts For 2010-'12 Land Rover Range Rover L322 With Variable Damping Suspension

Arnott Introduces Reman Front OE Air Struts For 2010-’12 Land Rover Range Rover L322 With Variable Damping Suspension

arnottlowArnott Air Suspension Products has announced the introduction of remanufactured front OE air struts for the 2010 to 2012 Land Rover Range Rover L322 with Variable Damping Suspension (VDS), including supercharged. Arnott’s air struts replace OEM Part Numbers LR032560 and LR032567.

Arnott says it thoroughly tests, cleans and repaints the original equipment before carefully rebuilding the part with a new, heavy-duty rubber air spring bladder from Vibracoustic. The remanufacturing process includes adding a new, heavy-duty crimping ring, new air fitting and new O-rings.

Arnott Part Numbers are AS-2757 (Front Right) and AS-2758 (Front Left). The Air Struts retail for $548.56 each. A refundable core deposit of $200 applies to each part. A detailed installation manual is included.

The parts are backed by Arnott’s Limited Lifetime Warranty in North America. They are covered by a two-year limited warranty in the rest of the world.

Arnott adds that while the highlighted remanufactured OE Land Rover Range Rover Air Struts are a great solution for luxury vehicle owners concerned about failing air struts leaving them stranded with expensive and recurring maintenance problems, Arnott offers an array of additional, innovative aftermarket parts for the Land Rover. For example, Arnott offers a revolutionary coil spring conversion kit for the latest generation Range Rover. Arnott’s elite Land Rover coil spring kit delivers a seamless and error-free conversion of the 2006 to 2012 L322, MK-III Range Rover suspension system, excluding supercharged.

The entire range of Arnott Air Suspension solutions for the Land Rover, including the Discovery II Series, and the LR3/Discovery 3 Series, can be reviewed here.

You May Also Like

Ride Height Sensors

If one of these sensors is replaced, it must be calibrated after it is installed.

Ride-height sensors not only measure the position of the suspension, but also the rate of movement. They are supplied with a voltage of around 5 volts. The signal voltage is changed as a magnet moves past a coil. Most sensors have three wires — ground, power and signal.

Internally, it is difficult to damage one of these sensors. Externally, the linkage that connects the sensor to the suspension arm can also be damaged. The connector can be damaged and cause a short or open and a code will be set. If one of these sensors is replaced, it must be calibrated after it is installed.

Ride Control For Electric Vehicles

Replacement units are available from sources other than the dealer.

Brake Pad Edge Codes

The “Edge Code” can tell you information about a brake pad’s friction material.

Chassis Parts and Alignment Angles

Knowing why the adjustment is required is critical to performing the total alignment.

Suspension Upgrades – Selling Shocks and Struts

The question customers fail to ask is, what is “best” for their vehicle?

Other Posts

Air Ride Suspension Diagnostics

The key to understanding the logic of air ride systems is using service information.

Steering Angle Sensor Operations

It is important for the ABS/ESC module to receive two signals to verify the steering wheel’s position.

Chassis Alignment

The source of the complaint can be the angles, electronics or tires.

Laying Out Your Shop for ADAS/EV Repairs

With so many vehicles equipped with some form of ADAS, rethinking your electronics layout or plan might be in order.