Jeep: Squeak-Like Sound From Rear Spring Isolator

Jeep: Squeak-Like Sound From Rear Spring Isolator

Models:
2005-‘08 (WK) Grand Cherokee
2006-‘08 (XK) Commander
This bulletin involves the replacement of the upper rear spring isolators, two in total, and orientation of the spring to prevent against reoccurrence.
Symptom/Condition
The customer may experience a squeak-like sound coming from the rear suspension of the vehicle. The squeak will occur most often when the rear of the body and the rear suspension move relative to each other. The squeak sound is typically caused by the misalignment of the rear spring upper pigtail in ­relation to the upper spring seat.
Diagnosis
With the vehicle parked and on a flat surface, rock the rear of the vehicle up and down. If the squeak-like sound occurs at one or more of the two upper rear spring isolators, then perform the repair ­procedure.
Repair Procedure
1. Replace the two upper rear spring isolators. Refer to the detailed repair procedures in TechCONNECT → Service Info Tab → 2 Suspension / Rear / Spring / Removal and Installation.
2. Orient both rear springs such that the upper pigtail end/gaps are facing rearward in the vehicle.
Courtesy of Identifix 

You May Also Like

Ride Height Sensors

If one of these sensors is replaced, it must be calibrated after it is installed.

Ride-height sensors not only measure the position of the suspension, but also the rate of movement. They are supplied with a voltage of around 5 volts. The signal voltage is changed as a magnet moves past a coil. Most sensors have three wires — ground, power and signal.

Internally, it is difficult to damage one of these sensors. Externally, the linkage that connects the sensor to the suspension arm can also be damaged. The connector can be damaged and cause a short or open and a code will be set. If one of these sensors is replaced, it must be calibrated after it is installed.

Ride Control For Electric Vehicles

Replacement units are available from sources other than the dealer.

Brake Pad Edge Codes

The “Edge Code” can tell you information about a brake pad’s friction material.

Chassis Parts and Alignment Angles

Knowing why the adjustment is required is critical to performing the total alignment.

Suspension Upgrades – Selling Shocks and Struts

The question customers fail to ask is, what is “best” for their vehicle?

Other Posts

Air Ride Suspension Diagnostics

The key to understanding the logic of air ride systems is using service information.

Steering Angle Sensor Operations

It is important for the ABS/ESC module to receive two signals to verify the steering wheel’s position.

Chassis Alignment

The source of the complaint can be the angles, electronics or tires.

Laying Out Your Shop for ADAS/EV Repairs

With so many vehicles equipped with some form of ADAS, rethinking your electronics layout or plan might be in order.