You searched for Mazda - Page 4 of 37 - Brake & Front End
Tech Tip: Mazda Experiences Vibration at Cruising Speeds (55 mph)

Some Mazda vehicles may experience a body vibration when driving approximately 55 mph. This symptom is due to the characteristics of the No. 3 and No. 4 engine mounts.

Tech Tip: Mazda Ticking Noise from Left Bank Cylinder Head

Some vehicles equipped with a 3.0L engine may exhibit a ticking noise from the left bank cylinder head while the engine is running at normal operating temperature.

BRAKE JOB: 2004-2009 Mazda3

The 2004-2009 Mazda3 is based on the Ford global C1 platform, shared with the European Ford Focus and Volvo S40. Nothing is really groundbreaking about the brake system. But, not paying attention to the details can end in a post brake job comeback.

Tech Tip: Mazda6 Engine Won’t Start in Cold Weather

In extremely cold weather (approximately -30 degrees C), a customer may experience an engine no start/no crank

Mazda Tech Tip: Clunk/Bang On Initial Forward Take-Off

Some customers may report a slight clunk, bang or jolt from the front of the vehicle. This concern will most likely occur during the vehicle’s first forward movement, and after the vehicle sits for a few hours and/or a cold soak. This is a normal operating noise of the Anti-Lock Brake System (ABS).

Tech Tip: Mazda Rattle Noise From Engine Due To Stretched Timing Chain

With the engine warmed up, some vehicles may exhibit a knocking/rattle type noise from the front timing cover and/or valve (cylinder head) cover below 2,000 rpm

Tech Tip: Correct Pulley for 1983-’87 Mazda 626 or 1986 B2000 Water Pump

There was a mid-year change by the original manufacturer to a different style pulley. CARDONE is now supplying two pumps, one with square pulley teeth and one with round teeth.

Tech Tip: Mazda Information Display Freezes in the Cold

Certain Mazda owners may complain of a problem with their vehicle’s information display during sub-zero temperatures. Some vehicles may experience no illumination from the information display when the ignition is turned on. Also, the clock runs too fast and may gain more than 20 minutes per week. To correct this condition, follow the Repair Procedure in this Tech Tip.

Tech Feature: Mazda6 and Mazda3 Driveability Diagnostics and Electronic Throttle Control

Drive-by-wire throttle control systems are pretty much trouble-free but have to be taken into consideration as you perform routine service and diagnose problems, and it changes the way you service these cars when it comes to cleaning the throttle plates, advises Bob Dowie, import specialist contributor, who also covers electronic throttle control’s tie in with ABS and VSC systems.

Tech Tip: Mazda6 and Mazda SPEED6 Information System Freezes in the Cold

Certain Mazda owners may complain of a problem with their vehicle’s information display during sub-zero temperatures. Some vehicles may experience no illumination from the information display when the ignition is turned on. Also, the clock runs too fast and may gain more than 20 minutes per week. To correct this condition, follow the Repair Procedure in this Tech Tip.