Ford Transit Premature Tire Wear
When the camber angle is out of specification, it causes premature wear of the inner or outer edges of the front tires.
Complete Wheel Bearing Service
The first step, and probably the most important, is inspection of the corner of the vehicle.
Alignment Specs: 2011-2017 Buick Regal
If you get a Regal in your alignment bay, you could be dealing with several new technologies at once. Options and packages on the Regal can be difficult to define by the badging on the trunk. Visual confirmation may be needed and you may also need to look up RPO codes. During the production run, there were models with Brembo brakes, all-wheel-drive and even advanced driver assistance safety systems (ADAS).
Brake Job: 2012-Current Cadillac ATS
There are two brake packages for the ATS. The base JE5 uses single-piston calipers in the front and rear. The J55 or J6 is typically found on the ATS-V, and uses larger rotors and a four-piston caliper in the front. There is also an option for a more aggressive track pad on the ATS-V.
WATCH: TTY Bolts For Suspension And Brake Components (Torque + Angle)
In this Tech Minute, Andrew Markel covers everything about TTY bolts and how their build could affect your next suspension repair. Brought to you by MEYLE.
Alignment Specs: 2006-2011 VW Jetta & Golf (A5)
Most entry-level VW models featured the same basic suspension used from the advent of the original VW Rabbit. About the only change was from a rear strut suspension to a separate coil spring and shock absorber in the rear. Used for all models of the Golf, Jetta, New Beetle and the Audi TT, this suspension is simple, durable and easy to repair. There is still a beam axle in the rear of pre-2006 FWD cars.
Buick Regal (2011-2016) Brake Pad And Rotor Replacement
The fifth-generation Buick Regal might seem like an easy car to repair on the surface when the pads need replacement, but if you assume that this is just another Buick, you could quickly find yourself in trouble.
Toe And Tie Rods
Toe is the most critical alignment angle. It is also an angle that can change as the weight of the vehicle is transferred to the front or rear wheels. Engineers can tune the suspension geometry and toe to make the vehicle more stable under braking or initial turn in.
2011-2017 Buick Regal Alignment
If you get a Regal in your alignment bay, you could be dealing with several new technologies at once. Options and packages on the Regal can be difficult to define by the badging on the trunk. Visual confirmation may be needed and you may need to look up RPO codes.
VIDEO: Aluminum Suspension Inspection
In most cases, an aluminum component is as strong or stronger than steel or cast iron. But what sets aluminum apart is how it fails. Most aluminum suspension components are extruded or forged, and in some cases, will be heat-treated. If a component has undergone extreme stress, such as a curb strike, the part will most likely crack and break instead of bend. Andrew Markel has a video introduction in which he answers a reader question about threadlocking compound.
