Cadillac CTS Alignment Spec
The first-generation Cadillac CTS was introduced in 2003 and ended production in the 2007 model year. The Cadillac CTS was built on GM’s rear-wheel drive Sigma platform. The CTS for years 2003-’07 came with two suspension packages — standard and sport. The packages have two different alignment specifications. The RPO codes for these packages can
Alignment Spec: 2005-2014 Ford Mustang
In 2005, Ford introduced a new Mustang with an all-new platform and clean-sheet design. While the formula of a live axle rear and MacPherson strut front end were the same from the previous model, Ford refined the design. These changes make for a vehicle that is easier to align and diagnose compared to the previous
Get Speed And Accuracy With New John Bean V2300 Imaging Wheel Alignment System
The new John Bean V2300 Imaging Wheel Alignment System is one of the most advanced products available today. With patented, high-resolution imaging technology, easy-to-use features and the award-winning AC400 Touchless Alignment Wheel Clamp, the V2300 will provide shops accurate and real-time measurements that improve performance and productivity, while at the same time enhancing the bottom
Expert Alignment Starts With Steering Angle Inclination
The most commonly misdiagnosed condition following a collision repair is often alignment related, according to Mark E. Olson, chief operating officer for Verifacts Automotive, and the reasons why are prevalent both inside collision repair shops and shops specializing in alignment. Olson, who is also a regional trainer for Hunter, got right to the point in
Corvette C6 Alignment Spec, 2005-’13
The 2005-‘13 Corvette is the sixth generation Corvette, often called the C6. There is nothing exotic about performing an alignment on a C6. In fact, you may find the C6 is easier to align than many cars and SUVs. Initial Inspection When going for a test-drive or pulling it into the shop, look at the
Toyota Sienna Alignment Service
The second-generation Toyota Sienna minivan is based on the Camry platform, and comes in both 2WD and AWD versions. When aligning this vehicle, there are three things you should know. First, a Sienna with stability control will require a recalibration of the steering angle sensor. Second, rear tire wear can be a problem on some
Alignment Service On 2011 Hyundai Elantra
The current platform of the Hyundai Elantra shares a lot in common with the other current Kia and Hyundai models. The simple architecture of a MacPherson strut front suspension and rear twist beam axle is starting to become standard on all small and mid-sized offerings. The Elantra is a “net-build” vehicle with no built-in adjustments, but adjustments can be made with aftermarket parts.
Performing An Alignment On Ford F-150 And Lincoln Mark LT Vehicles
The 2004-’08 Ford F-150 and 2005-’08 Lincoln Mark LT are not difficult vehicles to align, but they are difficult vehicles to properly inspect and adjust to the optimal specifications. The main difference with the 11th generation is in the front control arms. The lower control arm is forged aluminum. Upper ball joints have a reputation for failing sooner than lower ball joints.
Dodge Caliber Alignment Service
The Dodge Caliber was the replacement for the Neon. The Caliber shares the same architecture with the Nitro and Sebring models from the same timeframe. Needless to say, this is a “net build” vehicle with only toe adjustments built into the front and rear suspensions.
Honda Pilot Suspension And Alignment Inspection
The Pilot employs a strut-type front suspension that provides a generous 7.3 inches of wheel travel. Separate load paths to the unit body are provided for the coil spring and the shock absorber to reduce road noise. A solid 0.9-inch stabilizer bar is linked directly to the strut via ball-joint connections to reduce body roll during cornering maneuvers.