Video Archives - Page 65 of 69 - Brake & Front End

More Video Series

VIDEO: What Are High-Line And Low-Line TPMS Systems?

Andrew Markel describes the difference between high-line and low-line TPMS systems and the information displayed with each. Sponsored by Bartec.

high-line-low-line-tpms-video-featured
VIDEO: Why TPMS Matters To Technicians And Shop Owners

Andrew Markel explains why technicians and shop owners should not be afraid of servicing TPMS systems, and how the right training and tools can make any job easier. Sponsored by Bartec.

tpms-matters-video-featured
VIDEO: TPMS Sensor Fault On Toyota Vehicles

Andrew Markel shows how to use “test before you touch” and other methods to determine if a TPMS sensor fault is with the sensor itself or the TPMS module on the vehicle. Sponsored by Bartec.

tpms-toyota-fault-diagnosis
VIDEO: Clicking Noise After Wheel Hub Replacement

If a customer complains of a clicking noise after a hub unit has been replaced, two OEMs have each prepared their own solution to the problem, and they happen to be nearly identical. Sponsored by BCA Bearings.

wheel-hub-noise-clicking-video-featured
VIDEO: Diagnosing Undercar Noises During A Test Drive

Andrew Markel shows three tips to use during a test drive to diagnose noises relating to the wheel bearings, drivetrain and other components. Sponsored by BCA Bearings.

undercar-noise-test-drive-video-featured
VIDEO: TPMS Deactivation On Custom Rims

Andrew Markel shows how some shops have tampered with TPMS sensors when installing custom rims, and the dangers that it can cause. Sponsored by Bartec USA.

tpms-deactivation-custom-rims-video-featured
VIDEO: Live Axle Bearing Replacement

Andrew Markel describes how the breather is an often-forgotten but very important part to forget replacing on a live axle bearing job. Sponsored by BCA Bearings.

live-axle-bearing-video-featured
VIDEO: What Is The TPMS Light Telling You?

Andrew Markel shows what the TPMS light is saying in regards to inflation and system performance. Sponsored by Bartec.

tpms-light-diagnostics-featured-video
VIDEO: Measuring Flange Runout: Two Lug Nuts, Or Five?

Andrew Markel explains best practices for new brake rotor installation by checking flange runout with a certain amount of lug nuts attached and torqued. Sponsored by BCA Bearings.

flange-runout-video-featured
VIDEO: Key Fob-Based TPMS Relearns

Andrew Markel explains why getting the key fob from the customer is important in some TPMS relearn procedures. Sponsored by Bartec.

tpms-relearn-key-fob-video-featured
VIDEO: How Do Transmission Speed Sensors Work?

Andrew Markel shows the importance of the transmission speed sensor, and how it can reveal information such as if an automatic transmission is slipping. Sponsored by Standard.

transmission-speed-sensors-video-featured
VIDEO: Most Common Error When Installing Programmable TPMS Sensors

Andrew Markel discusses the most common error some shops make when installing a new set of programmable TPMS sensors on a vehicle. This comes from the support lines at Bartec USA. Video sponsored by Bartec USA.