Tech Tip: Chrysler Intrepid Won't Shift, DTCs Set

Tech Tip: Chrysler Intrepid Won’t Shift, DTCs Set

Automatic overdrive transmission goes into second gear (limp-in mode) and will not shift, and trouble codes for the transmission solenoid pack are stored in memory.

Affected Chrysler Intrepid Models:
1998-2002 2.7L, 1998-2001 3.2L, 1996-’97 3.3L and 1996-2002 3.5L

Symptom: Automatic overdrive transmission goes into second gear (limp-in mode) and will not shift, and trouble codes for the transmission solenoid pack are stored in memory.

Codes: P0750, P0755, P0760 and P0765

Problem 1 of 3: The transmission or electronic automatic transaxle (EATX) relay has a slower than normal response time causing the transmission control module (TCM) to set solenoid codes.

Test & Fix: Testing the response time of the transmission or EATX relay is usually unreliable. A quick test is to swap the relay with an identical relay on the vehicle or just replace it and retest.

Problem 2 of 3: The transmission solenoid pack has a solenoid winding that has higher or lower than normal resistance.

Test & Fix: Unplug the 8-way solenoid pack connector and check the resistance of each of the solenoid windings. Normal resistance is 1-3 ohms. Replace the solenoid pack if one or more solenoid windings have higher than normal resistance.

Problem 3 of 3: The TCM has one or more failed solenoid drivers.

Test & Fix: A labscope may be used to show that one or more solenoid drivers in the TCM is not fully grounding the solenoid while it is automatically performing the diagnostic test on it. The TCM is constantly monitoring the performance of the solenoids that are not currently being energized. Replace the TCM if one or more solenoid drivers are found to be defective.

You May Also Like

GSP Releases New CV Axle Part Numbers

GSP said 14 new CV axle part numbers are in stock and ready to ship.

GSP released 14 new CV axle part numbers. These parts are compatible with select Chevy, Chrysler, Subaru, BMW, Land Rover, Dodge and Hyundai vehicles.

The parts are in stock and ready to ship. Visit gspnorthamerica.com for more information.

Nissan CVT Clutch Point Relearn Procedure

The Adaptive Shift Control delivers responsive and powerful acceleration.

Diagnostic Test Drive For Drivetrain

A driveshaft center bearing can fail due to the bearing and the rubber isolator.

Constant-Velocity Axle Options

Whether new or remanufactured, complete CV axle assemblies can throw you a curveball from time to time.

10 Timing Belt Tips

Here are the some key installation and service tips to make your next timing belt job just a little easier.

Other Posts

Replacing Master Cylinders

The most common problems that occur in the master cylinder are wear in the piston bore and piston seal failure.

BCA Bearings Unveils 2024 Endless Summer Promotion

The Endless Summer promotion runs from May 1 through June 30, 2024.

PRT Launches 30 New Complete Strut Assemblies

The new items represent more than 10 million vehicles in new coverage, PRT said.

Axle Torque Procedures

Guessing the correct torque setting is a bad idea.