Tech Tip: Ford/Mercury Experiences Loss Of Second And Fourth Gear

Tech Tip: Ford/Mercury Experiences Loss Of Second And Fourth Gear

Some 2007-'08 Escape and Mariner vehicles equipped with a CD4E transmission may experience a loss of second and fourth gear. Begin the service procedure by checking the transmission fluid condition. Refer to Workshop Manual (WSM), Section 307-01A. Does the fluid condition pass evaluation?

Vehicles affected: 2007-’08 Ford Escape and Mercury Mariner

Some 2007-’08 Escape and Mariner vehicles equipped with a CD4E transmission may experience a loss of second and fourth gear.

Service Procedure
1. Check the transmission fluid condition. Refer to Workshop Manual (WSM), Section 307-01A.
Does the fluid condition pass evaluation?

a. No – this article does not apply, refer to WSM, Section 307-01A for normal diagnostics.

b. Yes – proceed to Step 2.

2. Remove the automatic transaxle.

3. Remove the torque converter and pump shaft from the transmission.

4. Remove the turbine speed sensor (TSS) from the pump; discard the TSS O-ring seal.

5. Position the transaxle so the pump assembly is facing upward.

6. Remove the servo cover retaining ring, servo cover, servo piston and return spring.

7. Remove the pump assembly while holding the rotating parts in place using a screwdriver inserted through the turbine speed sensor hole in the pump while removing the pump assembly. See Figure 1.

figure 1

8. Remove the intermediate and overdrive band assembly from the case. Be sure to get all pieces and make sure no contamination is left inside the transmission. See Figure 2.
– Choose the correct band for application from ­­
the kit:
 – four-cylinder engines require light-colored ­friction material; and
– six-cylinder engines require dark-colored friction material.

Figure 2

9. Install the intermediate and overdrive band assembly into the case.

10. Install the #1 pump support thrust bearing onto the pump support with petroleum jelly.

11. Install the pump assembly into the case with a new pump separator plate gasket and outer pump body O-ring.

12. Measure servo travel; select and install the correct length servo rod assembly.

13. Install a new servo cover and retaining ring.

14. Install a drain plug using thread sealer on the threads, torque to 25 Nm (18 lb.-ft.).

15. Install a new O-ring on the TSS sensor and install the sensor into the pump.

16. Position the transmission top side up.

17. Install the pump driveshaft and torque ­converter.

18. Install the automatic transaxle.

Courtesy of Mitchell 1

You May Also Like

AWD and ABS Services

AWD is always engaged and with the ABS brake modulator, can perform like systems with limited-slip differentials.

Many AWD systems came onto the market in the 1990s. Unlike 4x4 truck systems of the day, these systems were always engaged. Many of the early systems used electro-mechanical ways to manage the distribution of power to thefour wheels. 

Most of these systems used viscous differentials and limited-slip differentials with special fluids inside. These components were prone to failure and are expensive to manufacture. The performance of these systems could also be challenging to control with sensors and actuators.

Grinding/Rubbing Noise While Braking At Or Below 10 MPH

This tech tip involves complaints about brake noise in a Ford Escape Hybrid’s system.

Transmissions – CVT

Knowing what the common issues are & understanding the options available to isolate & fix problems are the keys to success.

Simplifying AWD Systems

No matter the manufacturer, there is almost always an all-wheel drive (AWD) option.

Manual Transmission Service

Parts that wear out must be replaced.

Other Posts

Transmission Fluid Hydraulics

You need to know how transmission fluid flows inside an automatic transmission.

Advanced Wheel Bearing Diagnostics

Can a bump set a wheel speed sensor code?

How Well Do You Know Your Driveshaft?

There are three types of modern driveshafts with multiple configurations.

Transmission Service

The following is an example of a dishonest vehicle and how to go about catching it in its lie.