Tech Tip: Muffled Rattle Sound from Front Suspension

Tech Tip: Muffled Rattle Sound from Front Suspension

Some Chrysler vehicles may exhibit a muffled rattle sound which may be heard during low speed driving on road surfaces with minor fluctuations (such as a parking lot) and may also occur during turning maneuvers. Keep reading to find out how to diagnose and repair this condition.

Chrysler Vehicles:
• 2004 (CS) Pacifica;
• 2003-2004 (RS) Town & Country/Caravan/Voyager; and
• 2003-2004 (RG) Chrysler Voyager (international markets).

Symptom/Condition:
The vehicle may exhibit a muffled rattle sound which may be heard during low speed driving on road surfaces with minor fluctuations (such as a parking lot) and may also occur during turning maneuvers.

Diagnosis:
If the vehicle exhibits the Symptom/Condition, perform the Repair Procedure.

Repair Procedure:
1. Raise the vehicle on a suitable hoist. Refer to the appropriate service manual, Lubrication & Maintenance, Hoisting.

2. Remove both front wheel and tire assemblies.

3. Remove the upper and lower sway bar link nuts and remove the say bar link.

Caution: When installing the nuts to the studs of the sway bar links, do not allow the stud to rotate in its socket. Hold the stud from rotating by placing an open-end wrench on flat machined surface on the stud.

4. Install the new sway bar link. Install the sway bar link nuts and torque to 88 Nm (65 ft.lbs.).

5. Perform steps 3 and 4 on the other side of the vehicle.

6. Install both front wheel and tire assemblies. Refer to the appropriate service manual, Tires/Wheels, Installation.

7. Lower the vehicle.

For additional information, visit www.mitchell1.com.

Technical service bulletin courtesy of Mitchell 1.

You May Also Like

Mullen Announces New CARB Certification

The certification is awarded to vehicle manufacturers who meet specific emissions standards in compliance with CARB regulations.

 Mullen Automotive, Inc., emerging electric vehicle (“EV”) manufacturer, announced certification from the  California Air Resources Board (“CARB”) on the 2025 Mullen THREE, Class 3 all-electric low cab forward chassis truck. The certification is awarded to vehicle manufacturers who meet specific emissions standards in compliance with CARB regulations. The District of Columbia and 14 states, including California, have adopted vehicle standards under Section 177 of the Clean Air Act (42 U.S.C. §7507), which requires additional approvals beyond EPA regulations.

Schaeffler Group USA Expands Product Portfolio

Seventy new parts have been added to the INA, LuK and Schaeffler Bearings portfolios in the first quarter of 2024.

Nissan CVT Clutch Point Relearn Procedure

The Adaptive Shift Control delivers responsive and powerful acceleration.

Hydraulic Power Steering Service Opportunities

Hydraulic power steering is still the choice for some platforms and applications.

Hunter Maverick Tire Changer: 19.5-inch Tire Service

Learn to handle 19.5-inch wheels, which are common on some delivery vehicles, with Hunter’s Maverick tire changer.

Other Posts

Curing Shock, Strut and Suspension Noise

As vehicles age, eliminating noise is Job 1. But ‘noise’ may mean different things to you and your customers.

Diagnostic Test Drive For Drivetrain

A driveshaft center bearing can fail due to the bearing and the rubber isolator.

Mobis Starts Construction of EV Battery System Plant in Spain

The new EV battery system plant will supply Volkswagen and is aiming for mass production by 2026.

Blink Charging UK, Evri Collaborate to Electrify Courier Fleet

EV chargers installed at Rugby enhance Evri’s sustainability efforts, supporting a greener future in parcel delivery across the UK.