You searched for Toyota - Page 13 of 114 - Brake & Front End
Tech Feature: Brake Job on 2004-2008 Toyota Corolla

The 2004-2008 Toyota Corolla was one of the best selling vehicles in North America. The front brakes for all models are, for the most part, the same. The only changes came in the configuration of the brake pad shims. The Corolla was not subject to the unintended acceleration recalls for floor mats or gas pedal.

BRAKE JOB: Toyota Tundra Brake Caliper Upgrade

If a 2000-’05 Tundra or Sequoia comes into your shop with a complaint of brake pulsation, there are a few diagnostic steps that should first be taken before ­repairs are recommended.

Tech Tip: A/C Inoperative, A/C Light Flashing on Toyota

This bulletin provides information regarding countermeasures to the A/C magnetic clutch relay for A/C light flashing (inoperative A/C)

More Trouble for Toyota

Automaker announces voluntary recall on 2010 model year Lexus SUVs; company also to pay record fine to NHTSA as a result of previous defects.

Toyota 4Runners Targeted by Catalytic Converter Thieves

Thieves in Charleston, SC, are targeting catalytic converters on Toyota 5Runners. A police spokesperson told WCSC News that these vehicles are being targeted because they sit high off the ground and the catalytic converters are often bolted on so they don’t need to be cut off.

Tech Feature: Brake Job on 1995-2004 Toyota Tacoma

The first-generation Toyota Tacoma was introduced in 1995 and continued until 2004. During the 10-year run, the basic brake system configurations did not change. But, Toyota did make changes to the pad shape and hardware to improve performance.

WORLDPAC Offers Toyota, Lexus and Scion Replacement Parts

WORLDPAC stocks more than 5,800 Toyota/Lexus/Scion replacement parts covering more than 65,000 applications.

Toyota Tech Tip: MIL On, Misfire DTCs Set on 1MZ-FE Engines

Some vehicles equipped with 1MZ-FE (V6) engines without VVTi may exhibit a rough idle and/or an MIL-on condition with a diagnostic trouble code or codes for misfire caused by an improperly operating ignition coil assembly. Production changes have been implemented to prevent this condition from occurring.

Toyota Announces Voluntary Recall on 8,000 2010 Model Year Tacoma 4WD Trucks to Inspect the Front Driveshaft

Safety recall issued to inspect the front driveshaft on a small production run of certain 2010 model year Tacoma 4WD trucks.

Breaking News: Toyota Announces Plan to Fix Accelerator Pedals on Recalled Vehicles and Ensure Customer Safety

Rigorously Tested Reinforced Pedals Will Eliminate the Excess Friction that Caused Sticking