Government Regulations and Braking Performance: How Uncle Sam Sets the Standards
Everybody wants safe brakes, right? You want the assurance that any brake linings you install on a customer’s vehicle will provide adequate braking and meet all applicable safety standards. But guess what? There are no federal safety standards for aftermarket brake linings. Federal Motor Vehicle Safety Standards (FMVSS) 105 and 135, which are issued by
Ride Control Repairs
Keeping Your Customers’ Tires Glued to the Road
Import ABS Diagnostics: Customer Input Can Help Pinpoint System Culprits
The ABS warning light is on in your customer’s car and he wants you to check it out. So where do you start your diagnosis? Because the ABS warning light is on, you know the ABS system has detected some kind of fault. But are there other problems that may be affecting the ABS system?
Tech Tip: Clutch Replacements – Don’t Turn Them Away
Clutch replacement does not have the prestige of driveability diagnostics, but at times, it pays better. Some shops turn away clutch replacements in fear of comebacks and lost productivity. But, clutch replacement offers the shop opportunities to sell additional services that might slip past the bottom line.
Nissan Suspension Repairs
Basic Safety Checks Benefit Both Your Shop and Your Customers
Tech Tip: Regular Fluid Flushes are Good for Transmissions
Out with the old and in with the new. Transmission fluid flushing is a service that replaces old worn-out automatic transmission fluid (ATF) with fresh new fluid to prolong the life of the transmission. Considering the fact that it costs $1,500 to $2,200 or more to replace a transmission or transaxle these days, the cost of a fluid flush is peanuts by comparison.
Inspection by the Numbers
As the saying goes: “The devil is in the details”. Another saying is: “The truth is in the numbers.” When performing a brake inspection, both are true. Replacing the calipers and rotors with every brake job may not be the cure all for ending all for fundamental brake repair problems. An inspection of every component,
Rotor Debate: Resurface or Replace?
More often than not, many rotors today are being replaced when the brakes are relined – and some motorists are complaining that new rotors really aren’t necessary. Resurfacing can usually restore the friction surface on worn rotors to like-new condition, unless a rotor is worn down too far to be safely resurfaced or has cracks,
Carley’s Corner: My Advice on Gas-Saving Gadgets
ely, these cars were introduced a few years too soon and were discontinued because of limited range (about 100 miles on a full charge), and the high cost of the batteries (GM’s cost was reportedly $500 for each battery, and each car held 18 batteries!). If GM were to re-introduce the EV1 today, buyers would
Rotor Debate: Replace, Discard or Machine?
More often than not, many rotors today are being replaced when the brakes are relined – and some motorists are complaining that new rotors aren’t really necessary. Unless a rotor is worn down too far to be safely resurfaced or has cracks, deep grooves, severe rusting, hard spots or other structural defects, resurfacing can usually