Tech Tip: Curing Muffled Rattle Sound Coming from Chrysler Suspensions

Tech Tip: Curing Muffled Rattle Sound Coming from Chrysler Suspensions

Some Chrysler vehicles may exhibit a muffled rattle sound which may be heard during low speed driving on road surfaces with minor fluctuations (such as a parking lot) and may also occur during turning maneuvers. Keep reading to find out how to diagnose and service this complaint.

Chrysler Vehicles:
• 2004 (CS) Pacifica;
• 2003-2004 (RS) Town & Country/Caravan/Voyager; and
• 2003-2004 (RG) Chrysler Voyager (international markets).

Symptom/Condition:
The vehicle may exhibit a muffled rattle sound which may be heard during low speed driving on road surfaces with minor fluctuations (such as a parking lot) and may also occur during turning maneuvers.

Diagnosis:
If the vehicle exhibits the Symptom/Condition, perform the Repair Procedure.

Repair Procedure:
1. Raise the vehicle on a suitable hoist. Refer to the appropriate service manual, Lubrication & Maintenance, Hoisting.

2. Remove both front wheel and tire assemblies.

3. Remove the upper and lower sway bar link nuts and remove the say bar link.

Caution: When installing the nuts to the studs of the sway bar links, do not allow the stud to rotate in its socket. Hold the stud from rotating by placing an open-end wrench on flat machined surface on the stud.

4. Install the new sway bar link. Install the sway bar link nuts and torque to 88 Nm (65 ft.lbs.).

5. Perform steps 3 and 4 on the other side of the vehicle.

6. Install both front wheel and tire assemblies. Refer to the appropriate service manual, Tires/Wheels, Installation.

7. Lower the vehicle.

For additional information, visit www.mitchell1.com.

Technical service bulletin courtesy of Mitchell 1.

You May Also Like

Toe Angles and Ride Height 

Zero toe angle is present when both tires are parallel to the center thrustline.

How can a mysterious case of tire wear occur in a perfectly aligned vehicle? It happens and the answers aren’t always simple. To better explain, let’s go back a few decades when I aligned a 1983 Mitsubishi RWD pickup, only to have it return a month later with a tire scuffing complaint. Although the outside edge of the right front tire showed evidence of toe-related wear, the current toe angle was 0.100 inches, which is within the Mitsubishi’s +0.080” to +0.350“ specification.

Sona Comstar Inaugurates Manufacturing Plant in Mexico

The new facility will specialize in producing differential assemblies and reduction gears meticulously designed for BEVs.

Axle Torque Procedures

Guessing the correct torque setting is a bad idea.

What Constitutes A Quality Wheel Hub Assembly?

Discover key factors to consider for quality hub assemblies and how they impact vehicle performance and longevity.

Needs Come First When Choosing Aftermarket Or OE

It’s essential to understand the differing needs of manufacturers, shops, technicians, and consumers.

Other Posts

Service Opportunities Still Exist With EVs

Like all ICE vehicles, you need the correct tools, parts and to follow the proper service procedures when servicing EVs. This video is sponsored by The Group Training Academy.

Do Technicians Need Tips?

Asking for a tip would not go over well with your future customers.

Wheel Bearing Shortcuts

When you’re installing a wheel speed sensor on a hub unit, never ever remove it from the original unit. Sponsored by Auto Value and Bumper to Bumper.

Green Li-ion Launches Lithium-Ion Battery Materials Plant

The plant is North America’s first commercial-scale plant to produce recycled lithium-ion engineered battery materials.