Tech Tip: Subaru Transmission Crossmember Service Tips

Tech Tip: Subaru Transmission Crossmember Service Tips

When performing service work or installing Subaru's accessory short-throw shifter, it's extremely important that the transmission is supported properly when removing or reinstalling the crossmember. If not, damage to the bolts and/or threads will occur.

When performing service work or installing Subaru’s accessory short-throw shifter, it’s extremely important that the transmission is supported properly when removing or reinstalling the crossmember. If not, damage to the bolts and/or threads will occur.

Support the transmission using a transmission jack, regardless if the vehicle is supported by a lift or car ramps. It’s recommended that hand tools be used for the removal and installation of the bolts. Inspect for bolt thread damage and replace as necessary. Be sure to clean any protective wax from the mating surfaces and to start all bolts several threads by hand before using tightening tools.

Note: If severe damage is evident to the threads, the use of a Heli-coil type kit is an approved repair method.

During reinstallation, use the torque sequence shown in Fig. 1 and the torque specifications shown in Fig. 2.


Note: Bolts must be torqued to the proper specifications.

Technical service bulletin courtesy of ALLDATA.

For additional information, visit www.alldata.com.

You May Also Like

Mazda Blind Spot Monitor Calibration (VIDEO)

Joe Keene discusses how to calibrate the blind spot monitoring system on a 2020 Mazda 6 Grand Touring.

Whether or not the blind spot sensor itself is damaged, if the rear fascia comes off, a calibration is called for.

Using both the sophisticated electronics of Hunter’s ADASLink diagnostic scan tool and old-school measurements with string and a plumb bob on a 2020 Mazda 6, Joe Keene demonstrates that the key to all ADAS calibrations is precision – and particularly so with blind spot sensors. ADASLink’s onscreen instruction ensures that precision by eliminating guesswork and providing an accurately performed and thoroughly documented calibration for more than 25 million vehicles.

Akebono Releases ProACT Brake Pad Kits for Honda, Ford, Lincoln and Toyota

Electronic wear sensor and premium stainless steel abutment hardware is included in the kits that require it. 

How to Maximize Cooling System Efficiency (VIDEO)

Do everything you can to help the system operate as intended. This video is sponsored by Rislone.

MSU Joins Statewide Effort to Promote EV Mobility Careers

A new a public-private partnership has been established to recruit electric vehicle and mobility talent to Michigan.

Decrypting Brake Pad Edge Codes

Learning the cryptic codes on the brake pad or shoe will tell you a lot of information.

Other Posts

Auto Pros on the Road: Curt’s Service

Detroit-area full-service facility completed an “all-green” expansion for comfort and safety of techs and clients.

Bartec USA To Host TIA’s ATS Class at Their Facility

Classes will be held from April 25-28.

J.D. Power Study: EV Market Growth Fuels Owner Satisfaction

Overall satisfaction with the BEV purchase experience is shifting to more traditional factors, like quality and styling.

Gen 1 Wheel Bearings

Removing and installing these bearings requires the correct tools and patience.