Tech Tip: Reverse Bleeding Basics

Tech Tip: Reverse Bleeding Basics

Many vehicles can develop release problems after a clutch change or replacement of the hydraulic release system components; usually consisting of a clutch master cylinder, slave cylinder and line. Conventional bleeding is usually done by opening the slave cylinder bleeder valve and either gravity bleeding or pumping the clutch pedal while opening and closing the slave bleeder valve.

Many vehicles can develop release problems after a clutch change or replacement of the hydraulic release system components; usually consisting of a clutch master cylinder, slave cylinder and line.

Conventional bleeding is usually done by opening the slave cylinder bleeder valve and either gravity bleeding or pumping the clutch pedal while opening and closing the slave bleeder valve.

Many new slave cylinders do not have a bleeder valve and must be reverse bled by simply filling the release system with hydraulic fluid and stroking the slave cylinder in and out several dozen times (slave must be lower than the master). This will force trapped air up and out of the vented master cylinder reservoir cap. Bleeder valve must be closed on slave cylinders that have them.

Ford Explorer, Ranger and Aerostar can really be hard to bleed because of the mounting position of the master cylinder. These applications respond very well to reverse bleeding if the master is first removed from the fire wall and leveled.

An animated version of reverse bleeding is available at lukclutch.com that should clear up any questions about reverse bleeding — especially those difficult Ford applications above.

Link to animated instructions:
http://bulletins.schaeffler-aftermarket.us/vidLib/lb171.phtml.

You May Also Like

Brake Problems

Reducing brake drag on late-model vehicles is not accomplished by a single component; it takes a system.

Drivers and technicians rarely make the connection between fuel economy and brakes. Moving the pads back from the rotor by only 1mm can increase fuel economy by as much as three to five percent. For engineers, it is a huge gain that does not involve exotic materials or adding expensive components.

The Real Cost of Installing Cheap Brake Pads

The brake repair market is starting to become dominated by a “good enough” mentality.

Brake Boosters and Start/Stop Vehicles

For a vacuum brake booster to work, it needs a source of vacuum.

Wheel Speed Sensor and Hub Unit Diagnostics

All wheel speed sensor codes are just the starting points of a diagnosis and not a reason to order a part.

Better Brake Law Update

Learn the latest about the salmon-inspired law.

Other Posts

Identifying Brake Issues With Brake Dust

Brake dust can indicate what could be wrong. This video is sponsored by Auto Value and Bumper to Bumper.

Axle Torque Procedures

Guessing the correct torque setting is a bad idea.

Top 10 Brake Mistakes

Here are the top 10 brake mistakes technicians can make.

Drilled and Slotted Rotors

There’s real science behind the location of holes, slots and grooves in today’s brake rotors. Plus, they look great too.