Tech Tip: Kia TCM Logic Revision

Tech Tip: Kia TCM Logic Revision

This bulletin provides information related to a logic change in the Transmission Control Module (TCM) for 2001 Rios, and 1998 through 2001 Sephia and Spectra vehicles built after Oct. 18, 2000. On vehicles built before that date, under certain driving conditions the following DTCs may be stored without a true defect being present: P0705, P0740, P0731, P0732, P0733 and P0734.

This bulletin provides information related to a logic change in the Transmission Control Module (TCM) for 2001 Rios, and 1998 through 2001 Sephia and Spectra vehicles built after Oct. 18, 2000. On vehicles built before that date, under certain driving conditions the following DTCs may be stored without a true defect being present: P0705, P0740, P0731, P0732, P0733 and P0734.

TCMs in vehicles built after Oct. 18, 2000 use a revised diagnostic routine software to reduce the incidence of related DTCs. The revised TCM should be used to repair affected vehicles experiencing a repeat incidence of the above-mentioned DTCs.

Note: The part number for the revised TCMs did not change. However, all TCMs currently in PDC stock have the revised logic.

Preliminary:
• Familiarize yourself with the procedures outlined in TSB, Transmission/Driveline 003. Obtain an A/T diagnosis worksheet and fill it out as you proceed.

• Check the A/T fluid for level and appearance. If the fluid is burnt or contaminated, the transaxle may have to be replaced per the instructions in the TSB before proceeding.

• Check for any (pending) DTCs, record their description and freeze-frame data. If any electrical or circuit related DTCs are stored, repair them before replacing the TCM or before attempting to correct DTCs that indicate system malfunctions.

• On repeat repairs, always check the vehicle’s repair history to determine previous repairs and whether they were effective. Use the repair history as required to aid in your diagnosis and repair procedures.

Inspection:
1. Open the driver’s door and check the production date on the FMVSS door label.
2. If the vehicle’s production date is Oct. 18, 2000, or later, the vehicle already has the correct TCM; no TCM replacement is required. Note: If the TCM has previously been replaced on this vehicle, it’s possible that an older version was inadvertently installed. When in doubt, check the TCM version regardless of the vehicle production date.
3. If the vehicle’s production date is before Oct. 18, 2000, determine if the correct TCM version has been used.
4. If the TCM is found to be an early version, proceed with step 5. Note: If the TCM is the correct version, and DTCs are stored, follow the appropriate procedures using DTC-specific checklists in the service manual and/or DTC-specific tips/information in the scan tool.

Repair Procedure:
1. Make sure the ignition switch is off and the gear selector is in the “park” position.
2. Locate the TCM under the left lower dash area.
3. Rio only: Loosen and remove the three mounting nuts that secure the ECM mounting bracket to the firewall (these are also used to secure the TCM).
4. Rio only: Loosen and remove the one remaining nut that secures the TCM mounting bracket to the firewall.
5. Sephia/Spectra: Loosen and remove the two nuts that secure the TCM mounting bracket to the firewall.
6. Remove the TCM, release the wire harness connector locking lever, then disconnect the TCM from the wire harness. Discard the old TCM.
7. Install the new TCM in the reverse order of removal.
8. Test-drive the vehicle after warm-up and check for (pending) DTCs. If any (pending) DTCs set during the test-drive, investigate them and correct as required. Use flight record data and follow the appropriate procedures using DTC-specific checklists in the service manual and/or DTC-specific tips/information in the scan tool.

Courtesy of IDENTIFIX.

For additional information, visit www.identifix.com.

You May Also Like

FCS Introduces 16 New Numbers

The new numbers cover some of the most popular applications on the road today, including the Jeep Compass, Lexus GX470, Mazda 3 and more.

FCS Automotive has announced the release of 16 new numbers including:

4 Air Spring to Coil Spring Conversion Kits (1,523,241 vehicle in operation)

1 Shock Absorber (1,225,184 vehicles in operation)

1 Suspension Strut (1,225,184 vehicles in operation)

10 Complete Strut Assemblies (3,368,969 vehicles in operation) 4 Shock Absorbers (3,553,593 vehicles in operation)

Maverick Tire Changer: Handling Large Custom Wheels

Large, custom 4×4 wheels are all the rage, and Hunter’s Maverick tire changer makes handling them a breeze.

Gen 1 Wheel Bearings

Removing and installing these bearings requires the correct tools and patience.

Introduction to the Maverick Tire Changer

Joe Keene speaks with Hunter Engineering service rep Rick Marzen on Hunter’s premium center-clamp Maverick tire changer.

Autel Energy Europe Releases MaxiCharger Launch Plan

Autel released the MaxiCharger Megawatt Charging System satellite launch plan at the Nordic EV Summit 2024.

Other Posts

RNR Tire Express Hosts Mother’s Day Giveaway

The eighth-annual event promises $100,000 in prizes, as well as a brand new 2024 Buick Encore for one select nominee.

Brand Refresh for Tires Plus, Hibdon Tires Plus Begins

Logo updates include a single-color tire mark; a logo palette comprised of Tires Plus yellow, black and red; and refined typefaces.

Schaeffler and Sustainability with Jerry Conroy

Conroy shares insights into his career trajectory, the evolving landscape of the company’s aftermarket operations, and more with Bill.

Flushing the Brake Fluid is Critical on Every Brake Repair

Making sure the brake fluid is the correct quality is critical. Sponsored by Auto Value and Bumper to Bumper.