Tech Tip: Diagnosing a Slow Cranking Starter or No Crank at All

Tech Tip: Diagnosing a Slow Cranking Starter or No Crank at All

A slow cranking starter or no crank at all may be caused by a faulty ground that prevents full voltage to the starter motor. Most people assume the starter is grounded because it is bolted to the engine. However, that does not mean it's grounded properly. The combination of road dirt, salt corrosion, engine heat and vehicle age can prevent a good starter-to-engine ground (metal-to-metal contact).

Application:
All vehicles with 12-volt starter motors.

Problem:
Slow cranking starter or no crank at all.

Cause:
Possible faulty ground that prevents full voltage to the starter motor.

Solution:
Most people assume the starter is grounded because it is bolted to the engine. However, that does not mean it’s grounded properly. The combination of road dirt, salt corrosion, engine heat and vehicle age can prevent a good starter-to-engine ground (metal-to-metal contact). A good ground path should measure zero voltage loss (no voltage drop). It is possible that a loose starter, corroded surfaces or faulty ground cables are stealing cranking voltage from the motor. If you just replaced the starter and it cranks slow or not at all, test for a proper ground by using a voltmeter – test, don’t guess!

Test Procedure:
Safely disable the ignition or fuel pump so the engine won’t start. Connect one voltmeter lead to a clean spot on the starter case, and then the other voltmeter lead to the negative battery terminal. Set the meter to the one volt DC scale. With key-on-engine-off, voltage must not exceed 0.1 volts. Now crank the engine for 10 seconds maximum while watching the meter readout. The voltmeter reading should not exceed 0.5 volts. If the voltage drop is greater, look for a ground cable problem or an improperly grounded starter motor as described above.

Tech Tip courtesy of CARDONE.

For additional information on products offered by CARDONE, visit www.cardone.com.

You May Also Like

R1234yf: Smaller Footprint, New Diagnostics

The benefit of R1234yf is simple. The new refrigerant lasts only 11 days in the atmosphere compared to 13 years for R134a. This is why the EPA is requiring R1234yf to be installed in all new systems by 2021.

r1234yf featured

The benefit of R1234yf is simple. The new refrigerant lasts only 11 days in the atmosphere compared to 13 years for R134a. This is why the EPA is requiring R1234yf to be installed in all new systems by 2021. The European Union required the changeover on Jan. 1, 2017.
So, what does this mean for independent shop owners and technicians? Currently, there are approximately 20 million vehicles on the road with R1234yf in the HVAC system. It is not a question of if, but when your shop will have to deal with one of these systems. While working on R1234yf systems is not that different from the R134a variety in operation or theory, identifying the refrigerant and recharging the system has some new twists.

Kia Tech Tip: Power Steering Oil Pump Noise

When replacing a power steering oil pump or inspecting a vehicle for a power steering whine noise, inspect the filter screen in the power steering reservoir for contamination.

Chevrolet Tech Tip: ABS Light On, DTC C1233

Don’t always jump to conclusions. A wheel-speed-sensor-related trouble code does not always mean that the sensor itself is faulty. SureTrack provides multiple possible solutions to one problem. In this situation, the problem is code C1233. Scan over this Real Fix and see if it is the right fix for you.

Anti lock brake system
2013 Ford: No Radio, No A/C, Airbag Light On

How many times have you been working on the computer when it suddenly locks up? Not one single key or command works, and the more you click, the less it responds. The only thing left to do is hold down those three magic keys, “Ctrl-Alt-Del,” or shut the whole thing off and restart the computer.

GM Tech Tip: Clunk Or Thump Noise From Front Suspension

Some customers may comment on a clunk or thump noise coming from the front suspension while driving over rough road surfaces. This noise will typically occur when the front suspension is returning to the upward position after a hard downward stroke, such as after driving through a large rut or pothole.

gm-suspension-noise-featured

Other Posts

Tech Tip: Ford/Lincoln/Mercury Transmission Fluid Leak

Follow these tips to diagnose and fix a transmission fluid leak on several Ford, Lincoln and Mercury models. The first step is to remove the LH halfshaft and inspect the halfshaft journal surface finish.

Transmission leak
Automotive Automatic Transmission Filter O-Rings And Lip Seals

Many transmission filters require a seal at the point where they assemble into the transmission. Most of these seals are called “lip seals,” although some filters may use an O-ring. Before filter installation, it is important to make sure that there is no O-ring or lip seal in the case or pump bore left over from the old filter.

BRAKELIGHT: The Car Cradle (March 1986)

Some ideas just never catch on… Related Articles – Welcome To The Future: Are Your Networks Protected? – BRAKELIGHT: BFE Sponsors Soapbox Derby – BRAKELIGHT: Spiffs from the 1970s (1976) I wonder if the Car Cradle paid for itself by shaking out the coins that were trapped in the seats? The ad claims that there

Welcome To The Future: Are Your Networks Protected?

For those of you who do not know me, I will give you a quick download on my background. Related Articles – BRAKELIGHT: Ford Helps Disabled Veterans (June 1951) – BRAKELIGHT: Wreck Display Increases Brake Business 150 Percent (August 1936) – Brakelights: Foam Means Fade (June 1961) I have been playing with cars for 40

cybersecurity