Tech Tip: Demystifying Honda ELDs

Tech Tip: Demystifying Honda ELDs

Even though Honda has used the Electronic Load Detection (ELD) System since 1988 on the Civic and 1990 on the Accord, there is still a lot of confusion on how this system operates and controls the charging system.

The ELD system inputs the electrical load to the ­engine control module (ECM), then the ECM controls the output of the alternator under various electrical loads, and is capable of completely shutting the alternator off under very low or no-load situations. When the vehicle is first started, the alternator may not begin charging for up to three minutes.

Before performing any tests on the charging system, be sure to put an electrical load on the vehicle electrical system by turning on the headlights or turning on the blower motor or rear defogger. The ELD unit, located in the underhood fuse box, must sense current flow through the fuse box so it can correctly indicate the electrical load on the vehicle to the ECM.

The ELD unit has three wires leading to it, a 12-volt power supply wire, a ground wire and a signal wire. On the signal wire, the ECM will send a reference voltage of approximately 4.5 to 5 volts to the ELD unit. The ELD will pull this reference voltage toward ground depending upon the amount of load on the electrical system. With no or little current flow through the ELD, the ECM will see approximately 3.5 volts on the signal wire. At this time, the ECM can ground the control wire at the alternator and the voltage regulator will turn off the alternator without illuminating the charge light. If the current flow is high, the voltage on the signal wire will be close to 1 volt.

The ECM will then see a high electrical load and stop grounding the control wire so the voltage regulator will allow the alternator to charge.

Disconnecting the control wire from the alternator will disable the ELD control of the charging system, thus allowing the alternator to charge normally. The most important thing to remember when testing the charging system is to be sure to add an electrical load (such as headlights).

Courtesy of Identifix, Inc.

You May Also Like

Mevotech Releases 237 New Chassis, Control Arm, Wheel End Parts

The release boosts coverage for domestic and import passenger vehicles, pickup trucks, SUVs and EVs up to model year 2023.

Mevotech announced the addition of 237 new part numbers which expand its premium TTX, Supreme and Original Grade product offerings.

The release significantly boosts coverage for domestic and import passenger vehicles, pickup trucks, SUVs and EVs up to model year 2023, according to Mevotech.

Release highlights include:

10 Timing Belt Tips

Here are the some key installation and service tips to make your next timing belt job just a little easier.

CVT Transmissions

The point here is not to fear a customer complaint about a CVT transmission. 

Mercedes 4MATIC Diagnostics

The Mercedes-Benz 4MATIC all-wheel drive (AWD) systems have been around for a while now.

Transmission Valve Body Service

Four basic items are necessary to start your own reprogramming ventures.

Other Posts

MEMA Celebrates 120th Anniversary

MEMA said the milestone “underscores the association’s enduring legacy and its pivotal role in advancing the future of mobility and the interests of vehicle suppliers.”

UniClutch Launches Clutch System in the United States

From Australian manufacturer Clutch Industries, UniClutch is a clutch system that delivers uncompromised performance.

MEMA Aftermarket Suppliers Becomes UAF Gold Lifetime Trustee

The partnership with UAF is a commitment to the future of the automotive aftermarket, MEMA Aftermarket Suppliers said.

Castrol Turns 125, Debuts New Market Strategy

As part of the new strategy, Castrol will explore opportunities in battery thermal management, digital and service solutions and data center immersion cooling.