Engine Tech Feature: Choosing the Right Fasteners for the Job
Some of the most stressed-out parts of a high-dollar
Using OBD II Diagnostics to Communicate with Your Customer’s Volkswagen
This article is about communication faults and problems that have occurred on Volkswagens over the last 10-plus years. Many of the same problems still exist on the newest models, but as these vehicles age, get repaired or damaged, problems come up that can challenge even the very best technicians.
Closing the Gap on Intake Manifold Gaskets
Back in the days when most engines had cast iron blocks, heads and manifolds, the intake manifold could be easily sealed with simple and relatively inexpensive die cut fiber faced metal gaskets (solid or perforated core). Sealer was usually required to ensure a leak-free installation.
Finding Check Engine Light Culprits on Nissan Models
This month, we’ll be taking a look at the Nissan line and some of the common causes for the check engine light to be lit, as well as some of the driveability problems that may result.
Diagnosing A/C Systems with Automatic Climate Control
Diagnosis is often the biggest challenge, especially if the cause of a no-cooling problem is not obvious. Is it the refrigeration circuit, an electrical problem or a control issue?
Tech Feature: Where Do You Start with Mercedes No-Start Diagnostics?
Hundreds of times a year, repair shops will get cars brought to them to repair a “No Start” fault. This article is going to discuss the process that it takes to make repairs when there are so many variables. Though this article will be focused on Mercedes-Benz, the steps can be used for any make or model.
Gearing Up for Timing Belt and Chain Work
Timing belts are a maintenance item on engines that have them, but what about timing chains? On most overhead cam engines that use a timing chain to turn the cams, there’s usually some type of chain tensioner or adjuster to keep the chain tight and to compensate for stretch as the chain ages. But on pushrod V6 and V8 engines, there is no chain tensioner to compensate for chain stretch. Consequently, after tens of thousand of miles, the chain loosens up, starts to make noise as it rattles against the front cover, and causes cam timing to retard. At this point the timing chain needs to be replaced.
Tech Feature: Returnless Fuel Injection Systems
If you’ve tried to find the fuel pressure regulator on many late-model engines by looking in the engine compartment, you won’t find it there because the regulator has been relocated to the fuel tank. Engines with “returnless” electronic fuel injection (EFI) systems have the regulator inside the fuel tank. The regulator is part of the fuel pump assembly and is usually located downstream of the in-tank fuel filter.
Oxygen Sensors Read the Amount of Unburned Oxygen in the Exhaust
The O2 sensors located in the exhaust manifolds provide the essential feedback for the fuel control loop that regulates the air/fuel mixture. On V6, V8 and V10 engines, there is one O2 sensor in each exhaust manifold. On four and straight six engines, there is usually only one O2 sensor in the exhaust manifold.