Brake Job Archives - Page 9 of 14 - Brake & Front End
Ford Edge Brake Replacement

Protect the caliper piston and boots when pushing the caliper piston into the bores. Make sure that the caliper guide pin boots are fully seated, or damage to the caliper guide could occur. The guide pin bolts are different sizes. The longer/bigger bolt is the upper guide pin bolt. Position the brake caliper and install the guide pin bolts. Tighten to 88 Nm (65 ft. lb).

Brake Pads: Understanding Friction And Formulations

How the components in the friction material shear, break and interact during braking can determine a pad’s friction level, noise and wear characteristics.

Brake pad arrangement
2011 Chevy Sonic Brake Job

The Chevy Sonic is GM’s compact car that took over where the Aveo left off. Redesigned in 2011, the Sonic uses front discs and rear drums and comes with ABS and stability control standard. The system has had few complaints or TSBs issued. Servicing the brakes is straightforward and does not require any special tools except a scan tool to bleed the ABS modulator.

2007-2013 GM Full-Sized Truck (GMT900) Brake Job

The GMT900 debuted in 2007 and came standard with ABS and stability control. Keep reading for best practices for performing brake jobs on GM’s GMT900.

brake job gm featured
Tech Tip: ABS Light On Or False ABS Activation After Wheel Bearing Hub Replacement

If you diagnose a bad hub bearing on one side of a vehicle, and the ABS wheel speed sensor or tone ring is integral to the bearing, you may need additional repairs to restore proper ABS functioning. In many cases, replacing one hub bearing will cause the driver to feel ABS false activation when coming to a slow stop on dry pavement.

Anti lock brake system
Brake Job: 2009-2015 Honda Pilot

The second-generation Honda Pilot shares the same platform as the Odyssey minivan and Accord. It also shares a lot of the same complaints concerning “warped” rotors. It is not excess heat that causes brake judder and pulsation, it is lateral runout and disc thickness variation (DTV). The Pilot is sensitive to disc thickness variation. This

Brake Job: 2012-Current Cadillac ATS

There are two brake packages for the ATS. The base JE5 uses single-piston calipers in the front and rear. The J55 or J6 is typically found on the ATS-V, and uses larger rotors and a four-piston caliper in the front. There is also an option for a more aggressive track pad on the ATS-V.

Brake Service On A Volkswagen Routan

The 2008-2012 Volkswagen Routan is a rebadged variant of the Chrysler mini van platform with revised styling, suspension tuning and brake service procedures. So this van has a bit of a split personality when it comes to servicing the brakes. The customers who drive the Routan and the Chrysler minivan are two different customers judging

2010-2013 Kia Soul Brake Repair

The 2010-2013 KIA Soul has one of the most trouble-free brake systems on the market. But, when some Kia Souls begin to push 50,000-70,000 miles, they can suffer more from cheap brake pad slaps and a lack of service to the calipers, ABS system and brake hardware.

Cheap Brake Pads

Selling cheap brake pads can help automotive technicians market their services, but what is the real cost of installing inferior quality brake pads?

BRAKE JOB: 2009-2014 Ford F150

There are more than 3.6 million 2009-14 Ford F-Series trucks on the road today, and the majority of these are the F150 model. The 12th generation of the truck, and specifically its brake system, has had very few problems, since most of the brake system was carried over from the previous platform. Front Brakes For

BRAKE JOB: 2010-14: Chrysler Sebring/200 + Dodge Avenger

The brakes on the Chrysler Sebring/200 and Dodge Avenger are relatively problem free. There are very noise or pulsation complaints. There are no recalls or specific TSBs for the brakes. Replacing the brake pads and rotors is straightforward. But, care has to be taken to make sure the calipers are free and the rotors are