PaceSetter Performance Products Offers Direct-Fit Catalytic Converter For 1998-2005 Passat, 1997-2006 Audi A4, A4 Quattro, A4 Cabriolet, 1.8L Turbo Engine

PaceSetter Performance Products Offers Direct-Fit Catalytic Converter For 1998-2005 Passat, 1997-2006 Audi A4, A4 Quattro, A4 Cabriolet, 1.8L Turbo Engine

PaceSetter Direct-Fit Catalytic Converters utilize mandrel-bent stainless steel tubing for maximum efficiency and CNC-machined thick steel flanges for a factory-like fit and good seal. This "undercar" catalytic converter (#324078), a direct replacement for the original equipment unit, has heat shields for the catalytic converter and provisions for the O2 sensor.

PaceSetter Performance Products, designers and manufacturers of quality-made, affordably-priced exhaust systems and components, now offers a direct fit catalytic converter for the 1998-2005 Passat, 1997-2006 Audi A4, A4 Quattro, A4 Cabriolet with the 1.8L Turbo Engine.
 
PaceSetter Direct-Fit Catalytic Converters utilize mandrel-bent stainless steel tubing for maximum efficiency and CNC-machined thick steel flanges for a factory-like fit and good seal. This “undercar” catalytic converter (#324078), a direct replacement for the original equipment unit, has heat shields for the catalytic converter and provisions for the O2 sensor. It is, however, not legal for use or sale in California.
 
Using EPA-approved catalytic converters for OBD II applications, PaceSetter created an extensive selection of OBD II applications for both foreign and domestic brand cars and light trucks – from Malibu to Camry and BMW to Escape.

For additional information, visit www.pacesetterexhaust.com.

You May Also Like

Ride Height Sensors

If one of these sensors is replaced, it must be calibrated after it is installed.

Ride-height sensors not only measure the position of the suspension, but also the rate of movement. They are supplied with a voltage of around 5 volts. The signal voltage is changed as a magnet moves past a coil. Most sensors have three wires — ground, power and signal.

Internally, it is difficult to damage one of these sensors. Externally, the linkage that connects the sensor to the suspension arm can also be damaged. The connector can be damaged and cause a short or open and a code will be set. If one of these sensors is replaced, it must be calibrated after it is installed.

Ball Joint Wear

As the wear increases, play increases inside the joint. 

Curing Shock, Strut and Suspension Noise

As vehicles age, eliminating noise is Job 1. But ‘noise’ may mean different things to you and your customers.

Pricing Alignments

Why ordering off the menu can hurt your shop and customers.

Toe Angles and Ride Height 

Zero toe angle is present when both tires are parallel to the center thrustline.

Other Posts

MEYLE Expands Electronics, Sensor Product Portfolio

The focus is on assistance systems and engine and transmission management, with more than 300 new part numbers.

FCS Introduces 42 New Numbers in May

Complete strut assemblies, shock absorbers, shock absorber assembly kits and suspension struts for popular VIO applications are included.

Philips Ultinon Drive 5000 LED Lightbar Line Expands

Lumileds has expanded the Philips Ultinon Drive 5000 series to include eight models.

DMA Adds New BrakeMaster Coverage

New coverage for Ford and Chevy includes popular pickup trucks and SUVs.