Making Sure You Get A Strong Spark (Video)

Making Sure You Get A Strong Spark (Video)

Complete combustion requires strong spark at the right time with the right compression. Sponsored by AP Emissions.

CC: In our last 2 videos, we looked at diagnostic tips related to Air and Fuel in our traditional conceptual framework of Air, Fuel, and Spark. This video will look at Spark.

Complete combustion requires strong spark at the right time with the right compression.

To check for weak spark, start by visually inspecting the spark plugs. Carbon, oil, and ash deposits can hinder performance. Glazing and other signs of heat damage like cracking can lead to weak spark. Are the spark plugs dirty, corroded, or cracked? Are the gaps set correctly? Look for weak spark visually, it should be bright blue. Ideally you test them with a spark plug tester.

Most modern cars have coil on plug ignition system.

  1. Test the ignition coil’s primary ignition circuit with a multimeter and note resistance. Resistance should typically be within 0.4 and 2 ohms. However, always check the manufacturers specifications and follow those for guidance.  If the resistance is out of normal range, then replace the coil of your spark unit.  
  2. Test the secondary circuit of the ignition coil. Most ignition coils should show secondary resistance between 6,000 to 10,000 ohms; however, refer to manufacturer specifications for the correct range. If a reading of zero is displayed, that signals that the coil has short-circuited and needs to be replaced, while an excessive reading signals that the coil is open, and also needs to be replaced.

Look for loose wires and test them for continuity.

In the first 3 videos we looked at how a catalytic converter works, what causes a PO420 code, and how CATs are killed by poison or heat. The next three videos focused on diagnostic tips grouped into the traditional conceptual framework of Air, Fuel and Spark. Across these 6 videos we took the opportunity to talk a little bit about what makes our AP Emissions “clean by design” catalytic converters a solution for today’s complex emissions control needs.

  1. We load our own specially engineered catalyst formulations on our bricks using a proprietary method that results in a more robust, durable, and efficient catalyzing brick than the competition.
  2. Our catalyst is dialed in for the application it is cataloged for.
  3. We include gaskets.
  4. Pipes and shells are made with stainless steel.
  5. Our 25,000 mile warranty is a testament to our confidence that they are designed to fit and built to last. You can trust AP emissions -We keep the light off.

This video is sponsored by AP Emissions Technologies.

You May Also Like

Limited Slip Supplement (VIDEO)

If the frictional properties are not correct, chatter will occur. Sponsored by Lubegard.

Welcome to the Lubegard Limited Slip Supplement overview. Clutch-based limited slip differentials are common on many automotive applications like trucks and SUVs, but they present a unique problem. These differentials often use different clutch configurations, either cone or flat type, made with various materials and frictional requirements. When both wheels have ample traction, the clutch plates bind together tightly, sending consistent power to each wheel. When one wheel slips, additional power is sent to the other wheel based on the frictional properties of the clutch packs. This is where the gear lubricants frictional properties play an important role in functionality and performance.

Rust and Corrosion Preventive Oil (VIDEO)

Your tools and equipment need to be protected from rust. This video is sponsored by Lubegard.

Auto Pros Team Visits Hybrid Shop of The Carolinas

Auto Pros on the Road puts the Babcox team into shops across the USA. This episode is sponsored by Autolite.

Nissan Around View ADAS Camera Calibration (VIDEO)

Always calibrate the around view monitor system after a collision.This video is sponsored by Hunter Engineering.

Collision Blueprinting with Alignment Equipment (VIDEO)

An alignment is usually called for prior to ADAS calibrations. This video is sponsored by Hunter Engineering.

Other Posts

AP Emissions Releases January New Part Number Update

The release includes direct fit EPA converters covering more than 6.6 million vehicles in operation.

Stainless Steel Did Not Kill The Exhaust Repair

Direct fit parts can be used to make an effective repair quickly.

ADAS Calibrations: Accessing the FCA/Stellantis Secure gateway

The secure gateway ensures no procedures are performed without the proper data. Sponsored by Hunter Engineering.

Ford F-250 Shock Replacement (VIDEO)

Follow along the step by step installation process of shocks on a Ford F-250. This video is sponsored by PRT.