How Often Should Fuel Filters Be Replaced?

How Often Should Fuel Filters Be Replaced?

Most late-model vehicles have no factory-recommended service for the fuel filter because the filter is a "lifetime" filter part of the fuel pump assembly buried inside the gas tank.

Q: How often should fuel filters be replaced?

A. Most late-model vehicles have no factory-recommended service for the fuel filter because the filter is a “lifetime” filter part of the fuel pump assembly buried inside the gas tank. So the only recommendation is to replace it if it is clogged or the fuel pump is being replaced. New fuel pump modules usually come with a new filter as part of the assembly, but if a customer is replacing the pump separately he should also change the filter and pickup screen.

On vehicles that have inline fuel filters, there may be a recommended service interval (typically 50,000 miles). But if the filter becomes clogged with dirt, rust or sediment from the fuel tank, it may have to be replaced sooner. Frequent fuel filter clogging would tell you the fuel tank is being contaminated with outside dirt, or it is rusting (a steel tank), or is flaking (older plastic tank). The fix here may require cleaning or replacing the fuel tank.

A common symptom of a clogged fuel filter is loss of high-speed power caused by a restriction in fuel flow when engine demand is high. If the filter becomes completely blocked, it will starve the engine for fuel causing the engine to die. Technicians will often cut open a clogged fuel filter to find out what caused it to clog up.

You May Also Like

Simplifying AWD Systems

No matter the manufacturer, there is almost always an all-wheel drive (AWD) option for most platforms.

No matter the manufacturer, there is almost always an all-wheel drive (AWD) option for most platforms. Most of these systems are designed to be transparent to the driver.

Many AWD systems came onto the market in the 1990s. Unlike 4x4 truck systems of the day, these systems were always engaged and could not be disengaged by the driver. Many of the early systems used mechanical ways to manage the distribution of power to the four wheels. Most of these systems used viscous differentials and limited slip differentials with special fluids inside. These components were prone to failure and are expensive to manufacture. Also, the performance of these systems could be challenging to control with sensors and actuators. Moreover, these AWD systems could cripple fuel efficiency.

Transmissions – CVT

Knowing what the common issues are & understanding the options available to isolate & fix problems are the keys to success.

How Well Do You Know Your Driveshaft?

There are three types of modern driveshafts with multiple configurations.

Reprogramming Transmission Control Modules

It’s understandable to have a lot of questions and fears about reprogramming. 

Manual Transmission Failure Causes

One of the most common reasons behind why a manual transmission fails is lack of lubrication.

Other Posts

Advanced Wheel Bearing Diagnostics

Can a bump set a wheel speed sensor code?

Driveshaft, Axle and Drivetrain Noise FAQs

These are some of the frequently asked questions about driveshaft, axle and drivetrain noise.

Drivetrain: Diagnostic Test Drive

Driveshaft problems can be spotted from the moment you put the vehicle in gear to pull it into a bay.

Transmission Valve Body Replacement

Learning how to perform drivetrain diagnostics and “in-the-car” repairs is important.