Cleaning Bearings The Right Way

Cleaning Bearings The Right Way

Proper bearing cleaning can mean the difference between good performance and bearing failure. If cleaning is done improperly, the bearing, shaft or housing may become damaged, creating a more costly repair job.

 While it’s important to handle any bearing with extreme care, SKF highly recommends following these specific procedures when cleaning bearings.

Cleaning Procedure:
1. To begin the cleaning process, soak the bearings in a metal basket suspended in a clean container or tank holding a recommended solvent soaking the bearings overnight, if possible. If a basket is not available, suspend the bearings with a wire, or place them on a metal plate at the bottom of the container.

Note: Do not rest the bearings directly on the bottom of the bucket (they may not clean as efficiently due to sediment on the bottom of the container).

2. After dirt and grease are removed, rinse the bearings in another clean bucket of solvent (See Fig. 1). figure 1

The bearings should then be thoroughly dried. The safest method is natural air-drying. Compressed air, which is free from condensed moisture, may be used to blow out the bearings, but only after all dirt and chips have been removed (See Fig. 2).figure 2

Note: If compressed air is used, do not allow bearings to spin and always wear safety glasses to protect your eyes from injury.

3. After cleaning, inspect the bearing thoroughly for nicks, leftover dirt and damage. Inspected bearings, which are considered “good” may be used again. However, if re-assembly cannot be done immediately, these bearings should be protected.

4. Dip the cleaned bearings in a protective lubricant, or coat all surfaces with a light grease (See Fig. 3).figure 3

Rotate each bearing to work the grease thoroughly in and around the roller and on the races. Then wrap the bearings in waterproof paper and place each in a clean box or carton (See Fig. 4).Figure 4

If cartons are not available, just wrap them in waterproof paper. Mark the outside of each package to identify the bearing enclosed.
Courtesy of SKF.

You May Also Like

Live Axle Wheel Bearing Service

Replacing rear wheel bearings on a live axle rear suspension requires a few extra steps when compared to a unitized bearing.

Replacing wheel bearings on a vehicle with a live rear axle may not be one of the most regular jobs you do, but it can be one of the most profitable. While the basics have not changed in more than 60 years, new seal materials and differential designs have added new wrinkles.

Ride Height Sensors

If one of these sensors is replaced, it must be calibrated after it is installed.

Ride Control For Electric Vehicles

Replacement units are available from sources other than the dealer.

Brake Pad Edge Codes

The “Edge Code” can tell you information about a brake pad’s friction material.

Chassis Parts and Alignment Angles

Knowing why the adjustment is required is critical to performing the total alignment.

Other Posts

Understanding Passive Wheel Speed Sensor Operation

Passive types of wheel speed sensors are still used in many applications so understanding their operation is important.

Threadlocking Compounds For Vehicle Corners

To get the most out of these “liquid” tools, you first need to know how they work.

Auto Care Association Launches REPAIR Act Video

The goal is to emphasize the need for federal REPAIR Act legislation, according to the Auto Care Association.

Valvoline Celebrates Female Service Center Employees

Valvoline is launching a social media campaign led by its female experts who are sharing automotive preventive maintenance tips to promote accessible vehicle care for all.