BMW Tech Tip: Noise When Turning the Steering Wheel

BMW Tech Tip: Noise When Turning the Steering Wheel

Some owners of E38s, E39s and E53s may complain of a squealing, groaning or grinding noise when turning the steering wheel.

Some owners of E38s, E39s and E53s may complain of a squealing, groaning or grinding noise when turning the steering wheel.

CAUSE:
The plastic slip ring assembly that fits onto the steering shaft inside the rubber boot where the shaft passes through the engine compartment bulkhead can score, causing a noise as the shaft turns. This scoring is caused by a problem between the two white slip rings and the fixed collar of the ring assembly.

CORRECTION:
Slip ring assemblies made from improved materials are now available. The improved parts can be visually identified by the black plastic internal slip rings; the earlier rings were white in color.

In case of a customer complaint, check if the noise is coming from the joint inside the rubber boot at the bulkhead. If this is the source of the noise, replace the plastic ring(s), P/N 32 31 6 759 546. (E38 and E39 require one, E53 requires two.)

SERVICE PROCEDURE:
1. Remove the lower steering column, per the repair manual, section 32 31 070.
2. E38 and E39: Mark the inner and outer shafts and pull them apart. Slide the plastic ring assembly off the shaft, and install the improved part. Align the marks on the shafts and reassemble them.
3. E53: Slide both plastic ring assemblies off the bottom of the shaft.

Technical service bulletin courtesy of ALLDATA.

For additional information, visit www.alldata.com.

You May Also Like

Manual Transmission Failure Causes

One of the most common reasons behind why a manual transmission fails is lack of lubrication.

The most common reasons behind why a manual transmission fails are lack of lubrication, incorrect lubrication and improper or no clutch release.

COMPLEXITY OF LUBRICATION

Lubrication should be simple, but in the modern world NOTHING is simple. There was a time when virtually all stick transmissions ran on 90w gear oil. The synchronizer rings were brass or bronze, the cars and trucks shifted around 3,000 rpm and we had 3- and 4-speed transmissions. Ninety-weight did not like cold weather and generated multiple complaints to the manufacturer due to cold-shift problems. You needed two men and a boy to shift one of the units on a cold day until the fluid heated up.

Wheel Bearing Hub Damage Repair

Noise is a classic sign of a bad wheel bearing or wheel hub bearing. Determining why the damage happened may take some time.

Electric Vehicle Battery Service

Don’t be afraid to work on battery packs. However, you should be mindful of the potential damage high voltages can cause.

ADAS Suspension Alignments

Look at the “big picture” and really consider how the vehicle will operate if things aren’t done correctly.

Building The Perfect Future By Mentoring

Share your stories of how you have helped others reach their goals.

Other Posts

Electric Power Steering Diagnostics

Load management for steering systems.

GRI Receives US DOT Certification For Safety

GRI tires will now incorporate the DOT code emboss on its side walls.

Active Ride Control Diagnostics

The key to servicing these systems is proper information and understanding precisely how these systems operate.

Brake Pad Errors and Mismatches

In order to make the right selection, you must do your homework while still remaining skeptical.