Akebono Releases 2009 Master Brake Catalog

Akebono Releases 2009 Master Brake Catalog

The 2009 Akebono Catalog being distributed this month will contain 28 new part numbers which have already been released in 2009 - 18 Pro-ACT and 10 EURO.

The 2009 Akebono Catalog being distributed this month will contain 28 new part numbers which have already been released in 2009 – 18 Pro-ACT and 10 EURO.  

We also have 20 new numbers are scheduled to be released during the remainder of 2009.

For more information on products offered by Akebono, visit www.akebonobrakes.com.

You May Also Like

Wheel Bearing Analysis

What creates endplay? What creates noise?

On a typical passenger vehicle weighing around 3,400 pounds, each pair of front-wheel bearings, as well as the rear-wheel or axle bearings, supports around 850 pounds, depending on the weight balance and driveline configuration. If it’s a 6,000-pound SUV, each bearing might carry about 1,500 pounds. This load is concentrated on the relatively small bearing surfaces, which do not even take into account the dynamic loads produced by cornering.

General Tire Launches Spring Passenger Tire Promotion

Consumers who purchase a set of 4 qualifying passenger General Tires can get up to a $70 prepaid Visa card.

ASE, Goodguys Partner to Promote Education, Careers

They are joining forces to showcase the wide array of career paths in the world of hot rodding and automotive service.

SMP Introduces 276 New Part Numbers

Included in the release is new coverage for 77 product categories.

Mitchell 1 to Hold Shop Management Workshop in Orlando

Registration now open for two-day training event.

Other Posts

Tesla Wheel Bearing Replacement

The process of replacing the hub unit on a Tesla is the same as many cars and light trucks.

Wheel Bearing Hub Damage Repair

Noise is a classic sign of a bad wheel bearing or wheel hub bearing. Determining why the damage happened may take some time.

Tesla Air Ride Service

Tesla’s air suspension is “smart” because it uses GPS information and vehicle speed to adjust suspension ride height.

Locking Hubs and Axles

The leading cause of IWE failure is water finding its way into the vacuum lines under the hood and in the wheel well.