Understanding ABS Modulator Problems
Mechanical issues with the ABS modulator, or hydraulic control units (HCU), are rare, but they can happen. With more and more vehicles on the roads with older ABS systems that have not seen proper brake fluid maintenance, mechanical issues are becoming more common.
The signs of a malfunctioning ABS modulator can mimic problems with calipers, brake hoses or the master cylinder. Common complaints often include pulling brakes, long stops and low brake pedal. The main cause of these issues is the valve seats and pintles can become stuck or not seat properly due to debris, corrosion or contaminated brake fluid.
Corrosion results in the depletion of the buffers and anti-corrosion additives in the brake fluid, as the ABS modulator has a variety of metals in close contact. As the brake fluid corrodes the lines that are brazed with copper and the ferrous components, ions of the metals are release into the fluid. Since the ABS modulator has different metals, they act as anodes and cathodes. Some attract ions of copper while others are eaten away.
For a valve in the ABS modulator, the ions can plate the pintles and seats. This can prevent operation by causing it to stick and even stay open.
Theory of Operation
To diagnoses ABS modulator valve problems, you have to know how they work to apply, hold or release the brakes. Each brake corner has two valves. The inlet/isolation valve isolates the brake corner from the ABS pump/accumulator and the master cylinder. The outlet/dump valve allows brake pressure to be released. These valves work together to perform the following braking tasks:
Apply
When the master cylinder applies pressure, it goes directly to the wheel because the outlet/dump solenoid is closed. This is a normal braking event. The unit is in a “passive” state. It is also the position the ABS system will go to if the system is disabled.
Hold
If the system senses a wheel is locked, the inlet/isolation solenoid is closed to prevent any more pressure from the master from reaching the wheel. The wheel might start to turn. This can create a brake-pull condition.
Release
If the wheel does not start to turn, the outlet/dump valve will open. This will release or bleed off the hydraulic pressure that is holding the wheel. The wheel will now rotate.
