GM: Simple Steering Noise Fix

GM: Simple Steering Noise Fix

Before you replace that Chevrolet Avalanche steering rack because of a variety of strange noises — wait. There might be a very simple repair.

Owners of the GM truck and SUV models listed below may comment that they are hearing a pop, click or clunking noise coming from their steering at low speeds when going over bumps. They could also report feeling a clunk in the steering wheel. All these concerns can be fixed easily by replacing a worn right steering rack bushing.

Chevy steering rack 1
Fig. 1

Applicable Models:

• 2007-‘13 Cadillac Escalade
• 2007-‘13 Chevrolet Avalanche, Silverado, Tahoe
• 2007-‘13 GMC Sierra, Yukon
*Hybrids excluded.

An easy way to check for a worn steering rack bushing is to slide under the front of the vehicle while it’s on the ground to get a clear view of the power steering rack. With the engine off, have another tech move the steering wheel back and forth or lightly bounce the vehicle’s front end. Watch for movement of the steering rack. If there is any perceivable movement, replace the steering rack bushing.

Chevy steering rack 2
Fig. 2

Follow this fast and easy procedure to get that worn steering rack bushing replaced:

1. Raise the vehicle.

2. Remove the oil pan skid plate, if equipped.

3. Remove the steering gear mount bolts (Fig. 1).

4. Remove the right power steering gear boot clamp completely from the boot and slide the boot out of the way (Fig. 2).

5. Slide the power steering gear mount and bushing to the right (Fig. 3).

Chevy steering rack 3
Fig. 3

6. Remove the power steering gear bushing from the mount (Fig. 4).

7. Replace the power steering gear mount bushing.
8. Slide the mount and bushing back in place.

9. Slide the power steering gear boot back in place and install the clamps.

10. Install the steering gear mounting bolts and tighten all four bolts to 74 lb.-ft. (100 Nm).

11. Install the oil pan skid plate, if equipped.

Lower the vehicle and take it on a test drive to confirm the noise has been eliminated.

Chevy steering rack 4
Fig. 4

Written by the ALLDATA Community Automotive Diagnostic Team, a select group of automotive experts dedicated to helping technicians fix hard-to-repair vehicles more efficiently. © 2014 ALLDATA LLC.

You May Also Like

Chassis Parts and Alignment Angles

Knowing why the adjustment is required is critical to performing the total alignment.

An alignment angle doesn’t change randomly. There is a cause-and-effect relationship between external and internal forces that can alter the geometry of a vehicle’s suspension. Having the alignment reading for only one angle on one corner is just like knowing the temperature without knowing if there is a tornado outside.

Suspension Upgrades – Selling Shocks and Struts

The question customers fail to ask is, what is “best” for their vehicle?

Air Ride Suspension Diagnostics

The key to understanding the logic of air ride systems is using service information.

Steering Angle Sensor Operations

It is important for the ABS/ESC module to receive two signals to verify the steering wheel’s position.

Chassis Alignment

The source of the complaint can be the angles, electronics or tires.

Other Posts

Laying Out Your Shop for ADAS/EV Repairs

With so many vehicles equipped with some form of ADAS, rethinking your electronics layout or plan might be in order.

Broken Springs

What is the cause for the failure? Why does it occur with specific vehicles?

The Importance Of ADAS Calibrations

Following best practices and using appropriate equipment ensure customer satisfaction and safety.

Why Do Vehicles Go Out Of Alignment

If camber, caster or toe are out of specifications, there is usually a reason why.