False ABS Activation After Wheel Bearing Hub Replacement

False ABS Activation After Wheel Bearing Hub Replacement

Bearing WSS
In many cases, replacing one hub bearing will cause the driver to feel ABS false activation when coming to a slow stop on dry pavement. False activation is usually described as a pulse in the brake pedal when not expected.

Vehicles: All ABS-equipped vehicles
Condition: Vehicle had wheel bearing hub replaced on one side.
Repair Procedure: If you diagnose a bad hub bearing on one side of a vehicle and the ABS wheel speed sensor or tone ring is integral to the bearing, you may need additional repairs to restore proper ABS functioning.

In many cases, replacing one hub bearing will cause the driver to feel ABS false activation when coming to a slow stop on dry pavement. False activation is usually described as a pulse in the brake pedal when not expected. The pulsation comes from the ABS valves cycling the supposedly locked up wheel. This is due to the difference in signal strength from the wheel speed sensors (WSS) side to side.

The problem is usually associated with the air gap difference or wiring and/or connector integrity. In many cases, removing the WSS from the other side, if possible, and cleaning the mounting surface may repair problem. The rust buildup actually lifts the WSS from the bearing, increasing the air gap and weakening the signal.

Another possible issue is play in the bearing causing sine wave frequency change and or AC voltage variation. The new bearing will have little to no play; the remaining hub has acceptable play, but can still affect signal strength. Again, the difference in signal from side to side may be enough to trigger false activation.

If WSS is integral and not serviceable, replacing the hub bearings in pairs may be the only answer. The ABS system is activating as designed, so no warning light will be illuminated in most cases. At least discuss this with customer to prevent unnecessary surprise repairs in the future and prevent the dreaded “It never did this before you worked on it” conversation.
Courtesy of Raybestos.

You May Also Like

Brake Problems

Reducing brake drag on late-model vehicles is not accomplished by a single component; it takes a system.

Drivers and technicians rarely make the connection between fuel economy and brakes. Moving the pads back from the rotor by only 1mm can increase fuel economy by as much as three to five percent. For engineers, it is a huge gain that does not involve exotic materials or adding expensive components.

The Real Cost of Installing Cheap Brake Pads

The brake repair market is starting to become dominated by a “good enough” mentality.

Brake Boosters and Start/Stop Vehicles

For a vacuum brake booster to work, it needs a source of vacuum.

Wheel Speed Sensor and Hub Unit Diagnostics

All wheel speed sensor codes are just the starting points of a diagnosis and not a reason to order a part.

Better Brake Law Update

Learn the latest about the salmon-inspired law.

Other Posts

Live Axle Wheel Bearing Service

Replacing rear wheel bearings on a live axle rear suspension requires a few extra steps when compared to a unitized bearing.

Wheel Bearings Components

Follow along to learn what you may encounter when dealing with a Gen 1 wheel bearing. This video is sponsored by The Group Training Academy.

Identifying Brake Issues With Brake Dust

Brake dust can indicate what could be wrong. This video is sponsored by Auto Value and Bumper to Bumper.

Axle Torque Procedures

Guessing the correct torque setting is a bad idea.